Advertisement
3
To install the NEST BOX,
you will need these pieces:
P3
P5
P6
× 8
× 4
× 6
4
To assemble the CHICKEN
RUN, you will need these
pieces:
P
P1
P3
× 4
× 4
× 6
465 SUPPLEMENTAL — 10 /16 — UST
ENDS:
P3
× 4
(2 per box end)
Attach nest box ends
with [P3] screws.
SIDE:
Attach the nest box side
P5
with [P5] screws.
LID:
PREP: Before attaching the nest
box lid, lay the nest box roof in
P
position and close the padlock
flap on the lid over the hardware
on the nest box face.
This will align the nest box lid
in the correct position.
PREP: Tap wood pegs
P
[P] into predrilled
holes indicated by
the
symbol.
P3
P6
ATTENTION: When attaching
the chicken run side panels
and the front panel, make sure
the panels align flush with
the outside edges.
Align the side
P1
panels flush with
the coop and attach
with [P ] screws.
for more wonderful cages, toys, and accessories for dogs, cats, birds, chickens, rabbits, ferrets and small animals, visit www.prevuepet.com
FLOOR:
× 4
PREP: Center the divider
stop bar from side-to-side
and flush with the outer edge.
Attach with [P3] screws.
Tip the nest box floor into position between the end
panels with the divider stop bar facing the coop interior.
DIVIDERS:
Insert the nest box dividers
into the slots by tipping the
inside corner (1) in first and
rotating the outside corner
(2) down into place.
Attach the nest box lid
hinges to the coop with
[P6] screws.
2
1
Align the front
P3
panel flush with
the sides and
attach with [P3]
screws.
Advertisement
