Zanussi ZI 720/8 FF Instruction Booklet page 19

Position the runners (A) at the top and bottom of the
inside of the kitchen unit as shown in the diagram
and mark the position of the external holes. After
preparing the holes, screw the runners to the kitchen
unit door using 3.5x16 mm screws.
Open both the appliance door and that of the kitchen
unit to approx. 90¡.
Place the little plates over the runners. Hold the
doors of the appliance and the unit together and
mark the holes.
Remove the little plates and make the holes with a
diam. of 2 mm. Replace the little plates over the
runners and screw in the screws provided (3.5x16
mm).
For the alignment of the kitchen unit door, if
necessary, use the clearance size of the slotted
holes.
At the end of the procedure, check that the doors of
the appliance and the kitchen unit open properly.
If the appliance is fixed to the side of the kitchen unit,
simply slacken the screws in fixing brackets (E),
move the brackets as shown in the figure and re-
tighten the screws.
A
PR33
8mm
PR34
PR35
E
E
D735
19