Electrical Connection - Zanussi ZI 718/12 K Instruction Booklet

The electrical connections
WARNING: THIS APPLIANCE MUST BE
EARTHED.
The manufacturer declines any liability
should this safety measure not be observed.
If the plug that is fitted to your appliance is not
suitable for your socket outlet, it must be cut off
and the appropriate plug fitted.
Remove the fuse from the cut off plug.
The cut off plug should then be disposed of to
prevent the hazard of shocks in case it should
be plugged into a 13amp socket in another part
of your home.
Important
The wires in the mains lead are coloured in
accordance with the following code:
Green and Yellow
Blue
Brown
If you fit your own plug, the colours of the wires
in the mains lead of your appliance may not
correspond with the markings identifying the
terminals in your plug, proceed as follows:
GREEN & YELLOW
BLUE
D207
Connect the Green and Yellow (earth) wire to
the terminal in the plug which is marked with the
letter «E» or the earth symbol
green and yellow.
Connect the blue (neutral) wire to the terminal in
the plug which is marked with the letter «N» or
coloured black.
Connect the brown (live) wire to the terminal in
the plug which is marked with the letter «L» or
coloured red.
The plug moulded onto the lead incorporates a
- Earth
- Neutral
- Live
Fig.12
13 AMP. FUSE
BROWN
CORD CLAMP
or coloured
fuse. For replacement, use a 13amp BSI362
fuse. Only ASTA or BSI approved fuses should
be used.
The plug must not be used if the fuse
cover/carrier is lost. The cover/carrier is indicated
by the coloured insert at the base of the plug.
A replacement cover/carrier must be obtained
from your local Zanussi Service Force Centre
whose address is listed in the Customer Care
Booklet which accompanies your instruction
manual.
This appliance complies with the E.E.C.
Directive No. 87/308 of 2.6.87 relative to radio
interference suppression.
This appliance complies with the
following E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage Directive)
and subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
Please ensure that when the appliance is
installed it is easily accessible for the
engineer in the event of a breakdown.
9