Advertisement
USAGE INSTRUCTIONS
>> To turn on, press and hold power button (1) for 2-3 seconds.
>> Press repeatedly to cycle through modes. Double click the power button to activate
strobe from any other mode. Single click to return to low mode.
>> To turn off, press and hold power button for 2-3 seconds.
TO RECHARGE:
>> Plug supplied USB cord in to a USB power source (500mA minimum) and then plug
gently in to the covered charge port on the back of the unit. A red LED will light up
to indicate charging is occurring and a green light indicates the Luna Fire RX is fully
charged.
>> Charge time is 3 hours for a fully depleted battery.
>> When fully charged, unplug Luna Fire RX from USB power supply, return port cover
gasket to original position and store charger cord until next use.
Luna Fire
RX
™
1
Advertisement
Table of Contents
Summary of Contents for Nathan Luna Fire RX
- Page 1 >> Plug supplied USB cord in to a USB power source (500mA minimum) and then plug gently in to the covered charge port on the back of the unit. A red LED will light up to indicate charging is occurring and a green light indicates the Luna Fire RX is fully charged.
- Page 2 Luna Fire ™ With included belt Remove strap to clip anywhere Change angle Cleaning and Drying IPX4 Weather Resistant Lamp Precautions Disposal...
Need help?
Do you have a question about the Luna Fire RX and is the answer not in the manual?
Questions and answers