Table of Contents
Advertisement
Door Reversal
Disconnect from the electricity supply.
Remove all loose item, including food, store food in
a cool place;
Gently lay the fridge/freezer on its back with the top
held away from the floor by 5-8 cm (2-3 inches) of
packing;
Remove the feet (2-3).
Unscrew the bottom hinge (1).
Slide out the lower door from middle hinge (H) and
remove the latter.
Slide out the upper door from pin (G), unscrew the
latter and then screw it down into the hinge
provided on the opposite side, after having
removed the small plugs which should then be
fitted on the opposite side.
Refit the upper door and the middle hinge on the
opposite side.
Screw down the bottom hinge (1) on the opposite
side by using the screws previously removed.
Refit the feet (2-3) on the opposite side.
Unscrew the handle. Refit it on the opposite side
after having pierced the plugs with a punch. Cover
the holes left open with the plugs contained in the
documentation pack.
The doors can be aligned by adjusting the middle
hinge.
The middle hinge can be adjusted horizontally, with
the help of a tool, after having slackened the two
screws.
Attention
After completion of the door reversing operation,
check that the door gasket adheres to the cabinet. If
the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that case,
wait for the natural fitting of the gasket or accelerate
this process by heating the part involved with a normal
hairdryer on a low setting.
17
Advertisement
Table of Contents
