Summary of Contents for Bull 32X SCSI-2 CD-ROM Drive
- Page 1 Bull 32X SCSI–2 CD–ROM Drive Installation and Using Guide ORDER REFERENCE 86 A1 15EG 00...
- Page 3 Bull 32X SCSI–2 CD–ROM Drive Installation and Using Guide Hardware December 2002 BULL CEDOC 357 AVENUE PATTON B.P.20845 49008 ANGERS CEDEX 01 FRANCE ORDER REFERENCE 86 A1 15EG 00...
- Page 4 Linux is a registered trademark of Linus Torvalds. The information in this document is subject to change without notice. Groupe Bull will not be liable for errors contained herein, or for incidental or consequential damages in connection with the use of this material.
-
Page 5: Table Of Contents
Planning Your SCSI Device Layout Determining Your SCSI Device Address . Setting the SCSI Address. Rear View and Jumper Pin Positions on the 32X SCSI-2 CD-ROM Drive . Chapter 3. Installing the 32X SCSI-2 CD-ROM Drive . Installing and Connecting the Drive Configuring the 32X SCSI-2 CD-ROM Drive . - Page 6 Avis de conformité aux normes du ministère des Communications du Canada . . 21 Canadian Department of Communications Compliance Statement . . 21 VCCI Statement . . 21 Radio Protection for Germany . . 21 Appendix B. Notices . 23 32X SCSI-2 CD-ROM Drive Installation and Using Guide...
-
Page 7: Safety Information
Safety Information DANGER An electrical outlet that is not correctly wired could place hazardous voltage on metal parts of the system or the devices that attach to the system. It is the responsibility of the customer to ensure that the outlet is correctly wired and grounded to prevent an electrical shock. - Page 8 32X SCSI-2 CD-ROM Drive Installation and Using Guide...
-
Page 9: Handling Static-Sensitive Devices
Handling Static-Sensitive Devices Attention: Static electricity can damage the device and your system unit. To avoid damage, keep this device in its anti-static protective bag until you are ready to install it. To reduce the possibility of electrostatic discharge, follow the precautions listed below: v Limit your movement. - Page 10 32X SCSI-2 CD-ROM Drive Installation and Using Guide...
-
Page 11: About This Book
About This Book This book provides information about the 32X SCSI-2 CD-ROM Drive, and how to properly set the jumpers, install the CD-ROM drive, and use the CD-ROM drive. Use this book along with your specific system unit and operating system documentation. - Page 12 32X SCSI-2 CD-ROM Drive Installation and Using Guide...
-
Page 13: Chapter 1. Overview
Chapter 1. Overview This chapter describes the features of the 32X SCSI-2 CD-ROM Drive and provides instructions for handling the drive and CD-ROM discs. The CD-ROM is a half-high, 5.25-inch, 8-bit, single-ended, tray-loading drive. Its distinctive features include the following:... -
Page 14: Front View Of The Cd-Rom Drive
Rear View of the CD-ROM Drive Note: Audio is currently not enabled on server systems. 1. Audio Line-Out Connector 2. Jumper Block and Pins 3. 68-pin SCSI Interface Connector 4. Power Connector 32X SCSI-2 CD-ROM Drive Installation and Using Guide... -
Page 15: Chapter 2. Preparing To Install The 32X Scsi-2 Cd-Rom Drive
A SCSI interface cable Verifying Your Software Requirements The 32X SCSI-2 CD-ROM Drive is supported on several operating systems, including AIX 3.2.5 or later. Ensure that your operating system supports this CD-ROM drive before you install it. Contact your service representative for assistance. -
Page 16: Planning Your Scsi Device Layout
Determining Your SCSI Device Address Before you install the 32X SCSI-2 CD-ROM Drive, you must set the SCSI address on the drive. First, you must determine which SCSI addresses are available to use. Then you choose an address and install jumpers on the drive to set the selected address. -
Page 17: Setting The Scsi Address
The SCSI address can be set from 0 to 6. Address 7 is reserved for the adapter. The 32X SCSI-2 CD-ROM Drive SCSI address is factory-set at 5. Refer to “Determining Your SCSI Device Address” on page 4 if you need instructions for selecting another SCSI address. - Page 18 Note: Jumpers are also installed in other positions on the jumper block to enable or disable other functions. Refer to “Rear View and Jumper Pin Positions on the 32X SCSI-2 CD-ROM Drive” on page 7 and to Table 2 as you go through the following steps to set the SCSI address on this drive: Attention: Be sure to read “Handling Static-Sensitive Devices”...
-
Page 19: Rear View And Jumper Pin Positions On The 32X Scsi-2 Cd-Rom Drive
Rear View and Jumper Pin Positions on the 32X SCSI-2 CD-ROM Drive The following figure shows the jumpers as they are set at the factory. 1 2 3 4 5 6 7 1. Audio Line Out Connector 2. Jumper Block and Jumper Pins 3. - Page 20 32X SCSI-2 CD-ROM Drive Installation and Using Guide...
-
Page 21: Chapter 3. Installing The 32X Scsi-2 Cd-Rom Drive
The 32X SCSI-2 CD-ROM Drive must be installed into an available system unit bay and connected to a SCSI cable and power cable. Refer to “Rear View and Jumper Pin Positions on the 32X SCSI-2 CD-ROM Drive” on page 7 as you go through the following steps to install and connect the drive: 1. -
Page 22: Configuring The 32X Scsi-2 Cd-Rom Drive
To verify the installation on an AIX system, type: lsdev -Cs scsi at the system prompt. Press Enter. A list of SCSI devices displays. An Available status indicates that the drive is installed and ready to use. 32X SCSI-2 CD-ROM Drive Installation and Using Guide... -
Page 23: Extending The Vertical Retaining Tabs
Note: Do not extend the two upper tabs when you operate the drive in the vertical position. Do not extend any of the tabs when you operate the drive in the horizontal position. Chapter 3. Installing the 32X SCSI-2 CD-ROM Drive... - Page 24 32X SCSI-2 CD-ROM Drive Installation and Using Guide...
-
Page 25: Chapter 4. Installing Device Driver Software
Chapter 4. Installing Device Driver Software Device driver software is provided in AIX and other operating systems that support this CD-ROM drive. However, if you should have to install device drivers, follow the installation procedures provided in your operating system documentation. This chapter provides instructions for installing device drivers on an AIX system. - Page 26 Press Enter. If you want to verify the installation, follow the steps provided in “Verifying the Installation” on page 10. 32X SCSI-2 CD-ROM Drive Installation and Using Guide...
-
Page 27: Chapter 5. Using The32X Scsi-2 Cd-Rom Drive
Chapter 5. Using the32X SCSI-2 CD-ROM Drive This chapter provides instructions for handling the 32X SCSI-2 CD-ROM Drive, as well as the CD-ROM discs. Note: This device is available as an auto-docking feature on some systems. See your system documentation for information about the auto-docking feature. -
Page 28: Handling Compact Discs
3. To close the tray, press the Load/Unload button, or gently push in the tray. Note: Be sure that none of the vertical retaining tabs are extended when you use the drive in the horizontal position. See “Extending the Vertical Retaining Tabs” on page 11 32X SCSI-2 CD-ROM Drive Installation and Using Guide... -
Page 29: Loading A Compact Disc Vertically
page 11. Loading a Compact Disc Vertically Note: The CD-ROM drive must be in the horizontal position if you are using an 8cm disc. To load a compact disc into a vertically mounted drive, do the following: 1. Press the Load/Unload Button to open the tray. The tray slides out of the drive. Make sure the lower vertical retaining tabs are extended. -
Page 30: Playing An Audio Cd
You must also have an audio software application installed. The headphone jack provides the connection for headphones using a 3.5 mm (1/8-inch) stereo mini-plug. The volume control adjusts the audio output level for the headphones. 32X SCSI-2 CD-ROM Drive Installation and Using Guide... -
Page 31: Appendix A. Communications Statements
Appendix A. Communications Statements The following statement applies to this product. The statement for other products intended for use with this product appears in their accompanying documentation. Federal Communications Commission (FCC) Statement Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. -
Page 32: European Union (Eu) Statement
(independent) approval of the manufacturer’s adapters, it is essential that other optional cards, not supplied by the manufacturer, do not use main voltages or any other excessive voltages. Seek advice from a competent engineer before installing other adapters not supplied by the manufacturer. 32X SCSI-2 CD-ROM Drive Installation and Using Guide... -
Page 33: Avis De Conformité Aux Normes Du Ministère Des Communications Du Canada
Avis de conformité aux normes du ministère des Communications du Canada Cet appareil numérique de la classe B est conform à la norme NMB-003 du Canada. Canadian Department of Communications Compliance Statement This Class B digital apparatus complies with Canadian ICES-003. VCCI Statement The following is a summary of the VCCI Japanese statement in the box above. - Page 34 32X SCSI-2 CD-ROM Drive Installation and Using Guide...
-
Page 35: Appendix B. Notices
Appendix B. Notices This information was developed for products and services offered in the U.S.A. The manufacturer may not offer the products, services, or features discussed in this document in other countries. Consult the manufacturer’s representative for information on the products and services currently available in your area. Any reference to the manufacturer’s product, program, or service is not intended to state or imply that only that product, program, or service may be used. - Page 36 32X SCSI-2 CD-ROM Drive Installation and Using Guide...
- Page 37 SOCIETE / COMPANY : ADRESSE / ADDRESS : Remettez cet imprimé à un responsable BULL ou envoyez-le directement à : Please give this technical publication remark form to your BULL representative or mail to: BULL CEDOC 357 AVENUE PATTON B.P.20845...
- Page 38 Customer Code / Code Client : For Bull Internal Customers / Pour les Clients Internes Bull : Budgetary Section / Section Budgétaire : For Others / Pour les Autres : Please ask your Bull representative. / Merci de demander à votre contact Bull.
- Page 40 BULL CEDOC 357 AVENUE PATTON B.P.20845 49008 ANGERS CEDEX 01 FRANCE ORDER REFERENCE 86 A1 15EG 00...
- Page 41 Utiliser les marques de découpe pour obtenir les étiquettes. Use the cut marks to get the labels. 32X SCSI–2 CD–ROM Drive Installation and Using Guide 86 A1 15EG 00 32X SCSI–2 CD–ROM Drive Installation and Using Guide 86 A1 15EG 00 32X SCSI–2 CD–ROM Drive Installation and...
Need help?
Do you have a question about the 32X SCSI-2 CD-ROM Drive and is the answer not in the manual?
Questions and answers