Subscribe to Our Youtube Channel
Summary of Contents for LaserPro Explorer
- Page 1 LaserPro Dealers of North America Explorer Beam Alignment Copyright Koser Enterprises, Inc 2006 Member of the LaserProNA.com group Rev 1.00003 Remember to always wear safety glasses while doing any open beam tests.
- Page 2 Please note when doing this the lid will be unstable. Take care not to bump or kock it in such a way to cause it to fall off the Explorer. When Moving the X-Axis arm form P1 to P2 raise the left end of the lid and move the X-Axis to the next position.
- Page 3 After the unit initialize the Display will look like this. Press the Up Arrow until the display looks like this. It will say Laser Test Press Enter and the display looks like this. Power should now read 5%. High wattage laser may need to be lowered to 4 or 3%.
- Page 4 Back Side of Mirror 3 Small burn mark (Place Pen mark just to left of burn mark for later identification as shown) Figure 2 Position X axis to P2 (Bring it all the way forward) Put a small pen mark to the side of this dot so you will know which dot was fired first.
- Page 5 If Mirror 2 requires adjustment you will need to shift the lid several inches to the right. Remove the 8 screws that hold the lid on. There are two on each side These are the two back screws Shift lid several inches to the right to expose Mirror 2’s Prism Mount Remember to always wear safety glasses while doing any open beam tests.
- Page 6 If your results are not similar to the above you will need to adjust mirror 2 so that only 1 burn mark and the red dot are visible on the test tape.. Mirror 2 Back of Explorer (Diagram 1) Mirror 4 Mirror 3 Remember to always wear safety glasses while doing any open beam tests.
-
Page 7: Lock Screw
Once you have adjusted the prism mount run the P2 burn again. If it lands on top of your original P1 burn your done. If not re-adjust to correct. You may wish to use a new piece of tape and run P1 and P2 again. - Page 8 Mirror 3 Pivot Access Panel Mirror 1 Access Panel Mirror 3 Prism Mount Screw 1 Left and Right Pivot Screw - do not adjust Screw 2 Up and Down P3 and P4 Burn Mark P3 and P4 Burn Mark Burn Mark From P3 Before adjustment After adjustment Remember to always wear safety glasses while doing any open beam tests.
- Page 9 (Lens is just holding tape for photo) To adjust mirror 1 you need to open up Access Panel on the left side of the Explorer See Previous page for location. Mirror 1 only determines that the beam hits the center of the lens.
- Page 10 Remove the vent plate on the left side, bottom, of the machine and remove the two thumb screws and the black mirror 1 cover. Adjust screws 1 and 2 only on any prism mount. One will be front to rear, while the other will be left and right.
- Page 11 Red Beam Adjustment To align the Red Beam adjust the prism mount for mirror 0 so that the red dot hits the burn mark on the tape on the bottom of the lens carriage from your final test of mirror 1’s adjustment. As the Red Beam is in a different Beam Path then the Co2 Beam locate the lens carriage in the location you wish the pointer to be most accurate.
- Page 12 X=.065, or as close as we can get. When you are satisfied with the location press the Enter button. Press the Start button. In about 20-40 seconds the Explorer will initialize and be ready to run. Run your rectangle job again. If satisfied with location you are done. If the location is still off start at the top of this page and repeat.
Need help?
Do you have a question about the Explorer and is the answer not in the manual?
Questions and answers