— that the fault is reported to Flygt or Flygt’s represen- check the proper tightening of all the bolts (use the tative during the guarantee period;...
DATA PLATE INTERPRETATION For plate data please refer to the “Installation, care and Jet aerator units are not provided with any special data maintenance” of the pump that forms part of the Jet plate. aerator unit. COMPONENTS OF JET AERATOR UNITS Jet aerator Ejector Type...
Jet aerator version S assembly drawing. Self supporting, S is the installation system recom- mended by Flygt. The oxygenation unit is placed on the Liquid temperature: maximum 40°C (104 °F). bottom of the tank without the need for any kind of The pump can only work in full-load conditions if at ancoring device.
Jet aerator version P — In some installations and working This system provides an automatic connecting foot points of the pumps, the noise fixed to the base of the tank, with the ejector mounted level of 70 dB, or the level speci- on it.
INSTALLATION Safety precautions General recommendations In order to minimize the risk of accidents in connection For correct installation, see the overall dimensions in with the service and installation work, the following the general arrangement drawing at the end of the rules should be followed: manual.
Sharpened support feet Installation in tank The sharpened support feet provided sink 1-2 cm into If installing in an empty tank, clean any debris or the tank bottom, ensuring stability of the unit even in coarse solid matter out of the sump before putting the the event of repeated start-ups or persistent vibration pump unit into operation.
Make sure that there is no ice on the inlet filter when property. starting up. ELECTRICAL CONNECTION Follow carefully the instructions in the manual of the Flygt submersible pump that forms part of the Jet aera- tor unit.
IMPORTANT! Periodic inspection of the handle and or fall over and injure people or the fixing elements between the pump and the pipes is damage property. very important. NOTE! Flygt does not assume any liability in the event of such work being done by unauthorised persons.
Jet aerator power cable and possible securing to walls by three unit. stainless steel ropes at mutual spacing of 120°. For further information on tools available, consult Flygt. End sections Made of hot-dip galvanised steel for use of protective Supplementary information basket to exclude leaves.