Advertisement

Operator & Service Manual
300P Standard
300P Deluxe
300P Series
LiteGait® is a Registered Trademark of Mobility Research, Inc.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LiteGait 300P Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Mobility Research LiteGait 300P Series

  • Page 1 Operator & Service Manual 300P Standard 300P Deluxe 300P Series LiteGait® is a Registered Trademark of Mobility Research, Inc.
  • Page 3 SERIAL NUMBER Serial Number of Your Device: Note: Please keep your serial number in a safe and secure location. The serial number must be provided when seeking service for your LiteGait® device. The serial number provides us access to technical information regarding your device. www.LiteGait.com 1-800-332-9255...
  • Page 5 IMPORTANT SAFETY INSTRUCTIONS ***WARNING*** READ ALL INSTRUCTIONS BEFORE USING LiteGait® MAXIMUM PATIENT WEIGHT: LiteGait® I 300P: 300 lbs MAXIMUM UNIT HEIGHT: 7 feet 6 inches Use only under the direct supervision of a health care profes-  sional or caregiver Brakes should remain in the locked position at all times until ...
  • Page 7 Service & Parts Department immediately. Here are some resources, which will be of help to you: CLINICAL SUPPORT: clinicalsupport@LiteGait.com SERVICE & PARTS DEPARTMENT: technicalsupport@LiteGait.com WEBSITE: www.LiteGait.com USER FORUM : www.LiteGait.org Sincerely, Customer Service Department Mobility Research www.LiteGait.com 1-800-332-9255...
  • Page 9: Table Of Contents

    Table of Contents Unpacking and Assembly .................. 10 Unit Diagram ..................... 13 About Your Unit ....................13 USING Your LiteGait® ..................14 I. Manual Yoke Adjustment ................14 II. Actuated Height Adjustment ............... 14 III FlexAble ...................... 14 IV. Control Unit ....................15 V.
  • Page 10: Unpacking And Assembly

    NOTE: Your LiteGait® may look different than the follow- ing images. NOTE: If you have any questions during installation, please contact Mobility Research Service & Parts Depart- ment for assistance. 1.) Inspect shipment and note 7.) Carefully cut all black plastic any visual damage to box and/or straps securing base to pallet.
  • Page 11 Line up the holes for bolts to be in- serted. 16.) Insert bolts, hand tighten Call Mobility Research Service & bolts (ensure one person holds Parts Department at 1-800-332- actuator steady until secure). 9255 Extension 7104 for assis- Tighten bolts using 5/16 inch tance during this assembly.
  • Page 12 This section intentionally left blank. www.LiteGait.com 1-800-332-9255...
  • Page 13: Unit Diagram

    LiteGait® Diagram 1. EZ Adjust Yoke Assembly 2. Buckle Assembly 3. FlexAble 4. Actuator Column 5. Handle Bar Assembly 6. Battery / Battery Compartment 7. Base/Frame 8. Total Locking Casters 9. Directional Locking Casters 10. Control Box NOTE: Your LiteGait® may look different than image above CONTROL UNIT: Junction box mounted in the base About Your LiteGait®...
  • Page 14: Using Your Litegait

    Using Your LiteGait® Manual Yoke Adjustment The LiteGait® 200P and 300P yoke utilizes the EZ Yoke Height Adjustment assembly. To adjust yoke height support yoke arm assembly and pull out spring pin. Once spring pin is pulled out, yoke height should be easily adjusted.
  • Page 15: Control Unit

    Using Your LiteGait® Control Unit Charging LiteGait Control Unit is the part of the LiteGait® that con- LiteGait® is equipped with a 24 volt battery pack trols the adjustment of the actuator. The control that needs to be charged on a weekly schedule. To STOP and Plug Icons box consists of the following recharge your battery follow the steps below.
  • Page 16: Adjusting Handle Bars

    Using Your LiteGait® Adjusting Handle Bar Configuration Locking and Unlocking Casters The handle bars are designed to be use for balance while using the LiteGait®. To adjust the height of the handle bars loosen each knob in equal portions. The knobs should only need to be turned once to free the handle bars.
  • Page 17 Using Your LiteGait® Page Intentionally Left Blank www.LiteGait.com 1-800-332-9255...
  • Page 18: Harness Application

    Using Your LiteGait® Harness Application The harness was designed to support a patient in an upright position, allowing for full hip extension. This upright posture plays a critical role in the effectiveness of the gait therapy performed with partial weight bearing.
  • Page 19 Using Your LiteGait® Harness Application - While Standing 1. Wrap harness around patient with lowest side straps even with GREATER TROCHANTER. 2. Connect buckles top to bottom. 3. Adjust side straps* to the patient from bottom to top, alternate sides and tighten evenly.
  • Page 20 Using Your LiteGait® Harness Application – In Supine 1. Roll patient away from you. 2. Attach groin piece and place harness on patient with half of the harness rolled and under patient. (Figure 1) Figure 1 3. Hold harness in place with lowest strap at greater trochanter 4.
  • Page 21 Training with LiteGait® Connect the Harness to your LiteGait® 1. Lock all four casters to make the device stationary and adjust the yoke to the correct position, giving the patient approximately 5 to 6 inches of head clearance. 2. Extend the overhead straps until they are long enough to reach the metal buckles on the harness. Attach the four buckles that hang from the overhead straps to the appropriate buckles on the harness.
  • Page 22 Using Your LiteGait® Stepping up onto Treadmill (Continued) 7. To exit the unit, reverse the process. Keep directional casters locked until the LiteGait® is at the end of the treadmill. It is helpful to ensure that the locking casters are nudged into an outward rolling position so they do not get caught on the treadmill as they roll.
  • Page 23: Unit Care And Maintenance

    Unit Care and Maintenance LiteGait® Maintenance Your LiteGait® has been specially designed to be durable and relatively maintenance free. The frame is constructed from high strength steel, and has been painted with a special powder coat to resist rust and scratches. Cleaning Frame, Handle Bar Grips and Covers Table Frequency FOLLOW FACILITY INFECTION CONTROL GUIDELINES.
  • Page 24 Grips / Covers / Caps Buckles Base Actuator *Replace As Needed Based on Condition Please Send Copy of Completed Form Every 6 Months to Mobility Research Service & Parts Depart- Fax: 480-829-0737 Mail: Mobility Research — Service & Parts Depart- ment Email: TechnicalSupport@LiteGait.com P.O.
  • Page 25 Unit Care and Maintenance EZ Adjustment Yoke Buckles Assembly Spring Pin on back of yoke support Pull back coverings on end of yoke should pull in and out with ease. The arms to expose buckle assembly. spring pin should always be aligned and Ensure the bolts securing the buckle inserted in one of the holes on the back assembly are tight and that the buckle...
  • Page 26: Troubleshooting

    Troubleshooting - Power System Symptom: Actuator Does Not Raise or Lower 1. Possible Cause: Resolution: Low Battery Charge / Battery need to be Charge the battery following the appropriate charging instructions until full Replaced. charge. If charging does not resolve issue contact Service & Parts Department for replacement battery information.
  • Page 27 Troubleshooting - Harness Symptom: Patient is complaining of groin or harness discomfort. 1. Possible Cause: Resolution: The harness wrap and/or the groin piece are The harness and groin piece should be securely tightened from the start.* The not tight enough. harness wrap should be tight enough to grab on to the fatty tissue around the abdomen.
  • Page 28: Parts List

    Parts List Parts List – Harness and Accessories Diaper Harness Harness Wrap w/Overhead straps and covers A rigid, washable cloth wrap used with attachments that pro- Diaper Harness Wrap HDJ-A vide postural support to the patient Junior Harness Harness Wrap w/Overhead straps, covers and groin pieces A rigid, washable cloth wrap used with attachments that pro- Junior Harness Wrap HJ-A...
  • Page 29 Parts List Parts List – Base HANDLEBARS ASSEMBLY HB26 Complete handlebars include handlebar arms and metal frame. COMPLETE Part of the handlebars that encompasses the circumference of Handlebars Base Box HB26E-A the actuator/post. Flat plate that sits between the posterior knobs to fasten and Handlebar Plate HB26E-B the handlebars base box.
  • Page 30 www.LiteGait.com 1-800-332-9255...
  • Page 31: Resource Directory

    Service & Parts Department Service@LiteGait.com ClinicalSupport@LiteGait.com Clinical Support Education@LiteGait.com Education Department Sales@LiteGait.com Sales Department POSTAL ADDRESS: Mobility Research P.O. Box 3141 Tempe, AZ 85280 LiteGait® is a Registered Trademark of Mobility Research, Inc. PO Box 3141, Tempe AZ, USA 85280. (2016US) www.LiteGait.com 1-800-332-9255...

This manual is also suitable for:

Litegait 300p standardLitegait 300p deluxe

Table of Contents