Page 2
The Triton VersaSafe™ is an automated cash receptacle and depository designed for indoor use only. The following sections provide the requirements for installing the VersaSafe™ for your particular site location. To assist you in preparing your site, a check list is provided of various steps that should be carried out prior to the arrival of your unit.
This document contains the information necessary for the preparation and installation of a Triton VersaSafe™. It’s impor- tant that the site complies with the requirements specified in this document. In addition, electrical wiring and mechanical systems must also comply with all relevant laws and regulations.
Page 4
ersa nsTallaTIon nVironmental reCautions When installing a VersaSafe™, some general environmental and power precautions must be consid- ered. Evaluate the location where the unit will be installed. To help ensure proper operation of the unit, ensure the environmental criteria listed in this checklist are met. VersaSafe™...
Page 5
ersa nsTallaTIon imensions Hort abinet “f ” erViCe imensions abinet ootPrint Anchor “footprint” - Allow sufficient extra space around the front and sides as necessary for access. Unit shown with Bill Acceptor bracket extended. En- sure there is adequate room for the door to swing open.
Check the contents against the enclosed packing list and report any bination. Successful entry will display “OPr” missing parts to Triton. Ensure you locate the whip antenna, if wireless TDL on the screen. Turn the dial to the right until Gateway modem is installed.
ersa nsTallaTIon rill ountinG oles Mark the location of the cabinet mounting holes on the concrete floor. This is accomplished as described below, (see figure 1). SELECTING THE INSTALLATION LOCATION 1. Move the unit to the location where it will be installed. Open the cabinet vault Choosing the right location for your door at least 90°...
Page 9
ersa nsTallaTIon nstall tandard nCHors ™ ersa loor 1. Ensure the mounting location is free of all debris that might prevent cabinet from leveling. Move the unit into position for mounting by aligning the base over the four holes drilled in the previous procedure. Place an anchor mount through the cabinet base and into one of the mounting holes.
Page 10
ersa nsTallaTIon oCkinG ersa ountinG lat WasHer nCHor Figure 6 Anchor bolt configuration nstall HemiCal nCHors ™ ersa loor Move the unit into position for mounting by aligning the base over the four holes drilled in the previous procedure. Ensure the area is free of all debris which might cause the cabinet not to be level. 2.
Page 11
ersa nsTallaTIon Thread the rod coupler onto the threaded rod until it is tight against the nut. The threaded rod used should be free of dirt, grease, oil or other foreign material. 5. Select the drive unit, insert it into a rotary hammer drill and engage the coupling to be used. 6.
Page 12
Corner holes allow passage of power, ground and communication wiring. Wiring to an external mount- ed antenna will run through the access holes and connect to the TDL Gateway wireless communica- tions systems. The USB cable provides power to the wireless modem.
Page 13
NOTE: New VersaSafe units will come pre-loaded with the current 2.4.4 SP5 software. If upgrad- ing unit, do not plug in TDL Gateway modem until software version 2.4.4 is loaded to system. If 2.4.4 software is not loaded, an error code will result notifying the user that the device is not found.
Page 14
ersa nsTallaTIon Ptional lintH nstallation TOOLS REQUIRED Optional Plinth (part no: 06100-08204) The optional plinth installation kit includes a four and one quarter inch (4 1/4”) tall Plinth, four (4) wash- ers and four (4) nuts. The plinth is used to raise the VersaSafe up off the mounting surface to facilitate access or ensure no foreign objects, such as water, enter the cabinet.
Page 16
ppendix (“Atm”) S utomAted eLLer Achine oftwAre greement importAnt: pLeASe reAd cArefuLLY: BY INSTALLING OR OTHERWISE USING THE ATM, YOU (AS THE OWNER OR LESSEE OF THE ATM). AGREE TO BE BOUND BY THE FOLLOWING TERMS AND CONDITIONS, INCLUDING, WITHOUT LIMITATION, THE WARRANTY DISCLAIMERS, LIMITATIONS OF LIABILITY AND TERMINATION PROVISION WHICH APPLY TO YOUR USE OF THE ATM SOFTWARE CONTAINED IN THIS ATM AND IS HEREBY LICENSED BY TRITON SYSTEMS OF DELAWARE, INC.
Page 17
oftwAre icenSe greement ompLiAnce miSSion tAtementS DISCLAIMER OF WARRANTIES AND LIMITATION OF DAMAGES TO THE EXTENT PERMITTED BY LAW, THIS ATM SOFTWARE, INCLUDING ALL INCORPORATED THIRD PARTY SOFTWARE, AND DERIVATIVES IS PROVIDED, “AS IS”. TRITON MAKES NO REPRE- SENTATIONS WITH RESPECT TO, AND DOES NOT WARRANT THE PERFORMANCE OR RESULTS YOU OR YOUR CUSTOMERS MAY OBTAIN BY USING THE ATM.
Page 18
ppendix ompLiAnce miSSion tAtementS DISCLAIMER The manufacturer of the Automated Teller Machine (ATM) product(s) described herein makes no representations or warranties, either expressed or implied, by or with respect to anything in this manual, and shall not be liable for any implied warranties of fitness for a particular purpose or for any indirect, special, or consequential damages.
ppendix ArrAnty tAtement Manufacturer warrants that the Products delivered to Distributor will perform in accordance with the Manufac- turer’s published specifications, and as outlined in the Manufacturer’s booklet entitled “Thirteen Months Parts Only Limited Warranty” for thirteen months from date of shipment in Long Beach, MS. Distributor acknowl- edges that it has received a copy of such booklet, that it has read its entirety and that it understands and agrees with its contents.
Page 21
ArrAnty tAtement efenSe of nfringement lAimS If notified promptly in writing of any action (and all prior claims relating to such action) brought against the Distributor based on a claim that Distributor’s use of the goods infringes a patent or other intellectual property right, and if given access by Distributor to any information distributor has regarding such alleged infringement, Manufacturer agrees to defend Distributor in such action at its expense and will pay any costs or damages finally awarded against Distributor in any such action, provided the Manufacturer shall have had sole control of the...
Page 22
ppendix nterpretAtion And ther Arole vidence This writing is intended by the parties as final expression of their agreement and is intended also as a complete and exclusive statement of the terms of their agreement. No course of prior dealing between the parties and no usage of the trade shall be relevant to supplement or explain any term used in these terms and conditions.
Page 23
ArrAnty tAtement Limited Warranty covers normal use. Triton does not warrant or cover damage: • occurring during shipment of the equipment or components from or to Triton’s facilities; • caused by accident, impact with other objects, dropping, falls, spilled liquids, or immersion in liquids; •...
Page 24
ppendix Should you specify the carrier, we recommend that you explore with this chosen carrier the policies and proce- dures regarding shipping damage claims prior to selecting them as your preferred carrier. If the equipment receives structural damage and is in an un-installable condition, Triton will work with you to arrange for a replacement unit to be shipped as soon as possible.
Page 25
ArrAnty tAtement AllS for ervice or epAir Calls for service or repair will be accepted from authorized service technicians only. End users must contact either the sales organization that placed the equipment or an authorized third party service organization to obtain service.
Need help?
Do you have a question about the Triton VersaSafe and is the answer not in the manual?
Questions and answers