Zetta Z82 Quick Start Manual

Zetta Z82 Security Camera Quick Start Guide
Overview
Congratulations on your purchase of Zetta Z82 security camera!
Zetta Z82 is an intelligent security camera with multiple triggering methods and multi auto
on/off modes. The camera comes with a built-in rechargeable battery which can record up to
9 hours continuous video and audio during typical use and standby for 1 month when motion
triggering (in max battery mode) is enabled. By plugging in a 5V DC adapter (not included),
it can achieve max 156 hours circular recording for surveillance on a 256GB microSD card.*
* Actual life and performance may vary depending on usage and settings; battery not replaceable
Features
Circular recording – loop back recording once memory card is full
Time stamp – put time stamp on video
Motion-triggered recording – select to record only when motion is detected, 1 month
standby (in max battery mode), work through glass and window
Auto gapless split file – gaplessly split files for every 10 / 15 / 20 minutes
Orientation – use when the camera is turning up-side-down
Full HD 1080p resolution
Configurable video quality – high / medium / low
Support max 256GB microSD(TF) card (for better performance, use card larger than
8GB, class 4 or above, and before use, format the card to FAT32 format only)
Package Contents
Please unpack your intelligent security camera and check that the following are included:
Zetta Z82 security camera
USB 2.0 Cable
Quick Start Guide
Note: The PC configuration tool "Camera Widget" is not included in the package, please
download it from http://www.zetta.com.hk
Zetta Z82 at a Glance
Camera Microphone
Motion sensor
Power
Firmware upgrade
Reset
or Format card
USB
microSD
www.zetta.com.hk
Charging
The camera comes with an internal rechargeable battery. To use the camera for the first time
or not using the camera for a long time, please fully charge the battery for at least 8 hours
and resync the time by using the Camera Widget (see section "PC Configuration Tool"). You
can charge your camera through the USB port of your computer, or an portable power bank,
or a 5V DC adapter or car charger.
To charge the battery through USB port, connect the USB cable to the USB port of the
computer and the camera. For details, please see the status below. The camera will function
as a mass storage device, you will not be able to record video at this moment.
To charge the battery through power bank, DC adapter or car charger, connect the charger
to the camera. For details, please see the status below. You will be able to record video while
charging, depending on the mode you set.
Recording
The power button is located at the back side of the camera. It can turn the camera on or off.
Start Recording
Insert a FAT32-formatted microSD card (please see "Format Card" on how to format the
card). Press and hold the Power button until the green LED is on (approximately 3 seconds),
and then release the button. When you see the green LED flashing, the camera is recording.
Otherwise, please see the status below.
Stop Recording
Press and hold the Power button until the orange LED is off (for approximately 3 seconds).
WARNING: Turn off the camera before removing the microSD card!
Status
Without external charger
Green LED on: camera is booting up
Green LED flashing: normal recording
Green / Red LED intermittent flashing: battery low and recording
Red LED on: no card, card fail, battery low or card full (not in circular recording)
Connecting to an external charger
Orange LED on: charging but no recording
Green LED on: charging completed but no recording
Green LED flashing: charging completed and recording
Green / Orange LED intermittent flashing: charging and recording
Red LED on: no card, card fail or card full (not in circular recording)
Connecting to computer
Orange LED on: charging
Green LED on: charging completed