Table of Contents
Advertisement
Available languages
Available languages
OPERATING INFORMATION
Warning : Before use ensure you have read, understood section 1 safety instruction.
Important : Before use, the operator is to visually inspect the jack for cracked welds, damaged or
missing parts or hydraulic leak.
Raising a vehicle
1.
Ensure that the jack and the vehicle are on a hard, level surface.
2.
Always ensure that the vehicle handbrake is engaged and that the vehicle wheels are
chocked.
3.
Consult the vehicle manual to determine the location of jacking points. Position the
jack under a suitable lifting point.
4.
Turn the handle clockwise, to close release valve. DO NOT over-tightens.
5.
Raise the vehicle to the desired height by pumping the handle up and down.
6.
Place axle stands beneath the locations recommended by the vehicle manufacturer.
7.
Turn the release valve slowly counter-clockwise to lower the vehicle on to the axle
stands.
Lowering a vehicle
1.
Turn the release valve clockwise to close it.
2.
Pump the handle to raise the vehicle off the axle stands.
3.
Remove the axle stands from beneath the vehicle.
4.
Turn the release valve slowly counter-clockwise to lower the vehicle to the ground.
NOTE: When the jack not in use, ALWAYS leave the saddle and ram fully retracted.
CAUTION: Keep hands and feet away from the hinge mechanism of the jack
IMPORTANT: Only fully qualified personnel should attempt maintenance or repair.
MAINTENANCE
Monthly Maintenance
Lubrication is critical to jacks, since they support heavy loads. Any restriction due to dirt or rust can
cause either slow jack movement, or extremely rapid jerks, causing damage to the internal
components. To keep the jack well lubricated, carry out the following steps.
1.
Lubricate the linkages, the saddle and pump mechanism with light oil.
Advertisement
Table of Contents
