Table of Contents
Advertisement
Quick Links
OPERATOR'S INSTRUCTION MANUAL
MODEL: ____________________
SERIAL: _____________________
DATE OF PURCHASE: ____________
PURCHASED FROM: __________________________
WARNING:
9475 PASCAL GAGNON STREET, ST-LÉONARD, QUEBEC, CANADA
© Copyright 2012, Alcor Inc.
GRIZZLY
861 000
THIS PRODUCT IS DESIGNED AND MANUFACTURED TO
PROVIDE SAFE AND DEPENDABLE SERVICE IF OPERATED
ACCORDING TO INSTRUCTIONS. THE MANUFACTURER
PROVIDES THE FOLLOWING INSTRUCTIONS FOR USE AND
CARE OF THIS EQUIPMENT AND RELIES UPON THE
PURCHASER TO SEE TO IT THAT THESE INSTRUCTIONS ARE
MADE CLEAR TO THE PERSONS WHO WILL ACTUALLY BE
USING THE EQUIPMENT. FAILURE TO DO SO COULD RESULT
IN SERIOUS INJURY OR EQUIPMENT DAMAGE.
GRIZZLY EQUIPMENT
TEL: (514) 325-1260 / 1-888-325-9953 FAX: (514) 325-9952
E-MAIL: info@alcor-inc.com
ENGINE MODEL: _______________
ENGINE SERIAL: _______________
1
Produced in collaboration with Technical Training & Compliance
Advertisement
Table of Contents
Summary of Contents for Alcor Grizzly HERCULES 861 000
- Page 1 USING THE EQUIPMENT. FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY OR EQUIPMENT DAMAGE. GRIZZLY EQUIPMENT 9475 PASCAL GAGNON STREET, ST-LÉONARD, QUEBEC, CANADA TEL: (514) 325-1260 / 1-888-325-9953 FAX: (514) 325-9952 E-MAIL: info@alcor-inc.com © Copyright 2012, Alcor Inc. Produced in collaboration with Technical Training & Compliance...
-
Page 2: Table Of Contents
Storage ....................................13 LIFTING ....................................14 STICKERS .................................... 15 INSPECTION CARD ................................16 Pre-use and inspection form for Grizzly 860000 Hercules mobile anchoring system ........... 16 References ..................................... 17 © Copyright 2012, Alcor Inc. Produced in collaboration with Technical Training & Compliance... - Page 3 OR FLAT, LEVEL GROUND. ABUSE AND OR MODIFICATION OF THIS EQUIPMENT VOIDS THE MANUFACTURER’S WARRANTY AND IS THE SOLE RESPONSIBILITY OF THE OWNER/USER, SHOULD ANY DAMAGE OR INJURY OCCUR. © Copyright 2012, Alcor Inc. Produced in collaboration with Technical Training & Compliance...
-
Page 4: Definitions
CSA, ANSI or other recognised standards that pertain to the work and equipment. © Copyright 2012, Alcor Inc. Produced in collaboration with Technical Training & Compliance... -
Page 5: Introduction
“Splat Bag” or other equipment available from fall protection equipment suppliers or by calculating the distance taking into account the length of the lanyard and shock absorber – one of these calculations is described in (See figure 1) © Copyright 2012, Alcor Inc. Produced in collaboration with Technical Training & Compliance... - Page 6 Metal (deck) of at least 22 gage and at most 20 gage For use on any other types of roofs, inquire with Alcor before using. © Copyright 2012, Alcor Inc. Produced in collaboration with Technical Training & Compliance...
- Page 7 It is recommended to keep the worker at least 1 foot back from the fall hazard (See figure 2) © Copyright 2012, Alcor Inc. Produced in collaboration with Technical Training & Compliance...
- Page 8 NOTE: sharp edges must be protected in such a way to avoid damage to the vertical lifelines or lanyards. The user must install protector cushions on all sharp edges. (See figure 3) © Copyright 2012, Alcor Inc. Produced in collaboration with Technical Training & Compliance...
- Page 9 The HERCULES Mobile Anchoring System must be placed vis-à-vis the workplace and it must be moved as required to in such a way to avoid a pendulum effect in case of a fall. ( See figure 4 © Copyright 2012, Alcor Inc. Produced in collaboration with Technical Training & Compliance...
-
Page 10: Use
The work area, the distance from the roof edge and any angle at which the users will work also need to be predetermined. © Copyright 2012, Alcor Inc. Produced in collaboration with Technical Training & Compliance... -
Page 11: Positioning On The Roof
For use in travel restraint mode, the user must anchor his safety lanyard to one of the blue rings located on the vertical post. ( See figure 5) © Copyright 2012, Alcor Inc. Produced in collaboration with Technical Training & Compliance... - Page 12 For use in fall arrest mode, the user must anchor his safety lanyard to one of the yellow pivot arms. No more than one user per yellow pivot arm. (See figure 6) © Copyright 2012, Alcor Inc. Produced in collaboration with Technical Training & Compliance...
-
Page 13: Training
Moreover, it is recommended not to store the HERCULES Mobile Anchoring System at height due to its weight and the risks of injury. © Copyright 2012, Alcor Inc. Produced in collaboration with Technical Training & Compliance... -
Page 14: Lifting
IT IS STRICTLY FORBIDDEN TO USE THE BLUE RINGS LOCATED ABOVE THE DEVICE AS AN ANCHOR POINT. (These rings are only to be used for lifting the equipment (See figure 7) © Copyright 2012, Alcor Inc. Produced in collaboration with Technical Training & Compliance... -
Page 15: Stickers
STICKERS At the time of visual inspection, it is necessary to verify the presence of the following stickers. If they are damaged, missing or unreadable, please contact Alcor to obtain replacement stickers. © Copyright 2012, Alcor Inc. Produced in collaboration with Technical Training & Compliance... -
Page 16: Inspection Card
Jacks Corrosion Wheels Other If non-compliance is noted, please label "Dangerous - Out of Order" and have unit repaired before reusing. Signed: _______________________________ Name (bloc letters): ____________________________________ © Copyright 2012, Alcor Inc. Produced in collaboration with Technical Training & Compliance... -
Page 17: References
References [To come] © Copyright 2012, Alcor Inc. Produced in collaboration with Technical Training & Compliance...
Need help?
Do you have a question about the Grizzly HERCULES 861 000 and is the answer not in the manual?
Questions and answers