Origaudio Wristler User Manual

PAIRING YOUR DEVICE
Turn on the speaker by holding the power button (Figure 1)
down for approximately 2 seconds; you should hear a
power-up noise and see a ashing white LED light on the front
of the speaker to indicate that the device is on and ready to
pair. In the wireless pair settings of your mobile device,
connect to the device named "Wristler". You will hear a noise
and see the white LED light turn solid, ensuring a successful
pair. The speaker will automatically turn off if no devices are
paired after 15 minutes. To connect to a new device, (while
turned off) hold down the power button for 5 seconds until you
hear noise. This tone means it's scanning for a new device.
TRUE WIRELESS STEREO PAIRING
Turn on the Wristler, simultaneous holding "+" and "-" on
any Wrister for 2 seconds, you should hear a connected
noise on the Wristler and see a ashing white LED. Connect
your devices to the Wristler to enjoy stereo music now.
POWER OFF YOUR SPEAKER
Holding the power button (Figure 1)) down for approximately
2 seconds until hear the power-off noise.
CHARGING
Connect the USB charging cable to a power source and
insert the micro USB tip in the charging port located
underneath the port ap. Charge the Wristler (approx.
1.5hrs) before use. The LED light will turn red while the
speaker is charging and turn off once fully charged.
FUNCTIONS
1. Power ON/OFF/Play/Pause/Call
2. Previous Track （ Short press）
Volume-(Long press)
3. Next Track(Short press)
Volume+(Long press)
4. Micro USB Charge Port
5. Speaker
2. 1. 3.
4. 5.