Advertisement
Quick Links
Advertisement
Summary of Contents for Empava EMPV-WIT02
- Page 1 EMPV-WIT02...
- Page 3 TESTING YOUR WALK-IN TUB BEFORE INSTALLATION BY FOLLOWING PROCEDURES 1.Before unpack the unit,please inspect the carton carefully for any damage.any damage,please take a picture or record all admage carefully.if necessary,contact your dealer/distributor immediately. to file a freight claim. 2.Unpack the carton,then inspect thr carton carefully for any damage and check if all the spare parts are there .if there is any damage,please take a picture or record all it carefully .if necessary,contact your dealer/distributor immediately.
- Page 4 Filter screen...
- Page 5 Size chart turn on hot/cold water pneumatic switch hydrodynamic adjust transfer water inlet/shower head water jet shower head drainer Water and electricity installation drawing...
- Page 6 12.This unit must be connected to a circuit that is protected by a Ground Fault Circuit Interrupter(GFCI).The GFCI should be provided and installed by a licensed electrician and tested on a regular basis (at least monthly).To test the GFCI push the test button.TheGFCI should interrupt the power.Push the reset botton and the power should be restored.if the GFCI fails to operate in this manner there is a possibility of an electric shock ,do not operate this unit.disconnect the unit and have the problem...
- Page 7 waterfall open sprinkler A.Waterfall/Sprinkler transferable switch(Marked with Icon) B.Controls the water inflow and the water temperature: Up the handle to open, otherwise down the handle to close close cold water inflow (You pull up the handle higher; the water force will be stronger.Otherwise, the water force will be weaker.) ;...
- Page 8 Door lock: Inward opening door lock steps to close the door close the door,press the door handle downward steps to open the door Lift up the handle,open the door Notice: 1.the water tight system is well design and professional. you do not need to press door handle downward with so much strength,so that you can lift up the door easily when you open the door.
- Page 10 SYMPTOMS PROBLEMS SOLUTIONS Door leaks 1.Door lock is not closed 1.Close the door lock slightly tightly; tightly; 2.There is some debris on the 2.Clean the debris on door seal. door seal. Cannot 1.Power is not normal(Low 1.Insert the plug tightly; control the voltage;...
Need help?
Do you have a question about the EMPV-WIT02 and is the answer not in the manual?
Questions and answers