Advertisement
Table of Contents
CASE FOR 7"-DISPLAY AND RASPBERRY PI4
RB-LCD-7P4-Case
1. GENERAL INFORMATION
Dear costumer,
thank you very much for choosing our product. In the following, we will
introduce you to what to observe while starting up and using this
product.
Should you encounter any unexpected problems during use, please do
not hesitate to contact us.
www.joy-it.net
Pascalstr. 8 47506 Neukirchen-Vluyn
Advertisement
Table of Contents
Summary of Contents for Joy-it RB-LCD-7P4-Case
- Page 1 CASE FOR 7“-DISPLAY AND RASPBERRY PI4 RB-LCD-7P4-Case 1. GENERAL INFORMATION Dear costumer, thank you very much for choosing our product. In the following, we will introduce you to what to observe while starting up and using this product. Should you encounter any unexpected problems during use, please do not hesitate to contact us.
- Page 2 Take the front panel of the housing and insert the display into the cut-out. Now connect the cables which are in the scope of delievery of the display, to the display board. Make sure that the display cable is aligned correctly. www.joy-it.net Pascalstr. 8 47506 Neukirchen-Vluyn...
- Page 3 Screw the Raspberry Pi 4 onto the spacers of the display board after all cable are placed on the display. Connect the cables to the Raspberry Pi 4. Ensure that the display cable is correctly aligned. Display-Pin Raspberry-Pin Pin 14 (GND) Pin 2 (5V) Pin 3 (SDA) Pin 5 (SCL) www.joy-it.net Pascalstr. 8 47506 Neukirchen-Vluyn...
- Page 4 Place the fan on the inside of the housing. The fan is screwed from the outside with the long black screws. www.joy-it.net Pascalstr. 8 47506 Neukirchen-Vluyn...
- Page 5 The red cable must be connected to pin 4 (5V pin ) and the black cable must be connected to pin 6 /( GND pin ). Finally, screw the back of the case to the display. Take care not to pinch the cables and place them so that they can not reach into the fan. www.joy-it.net Pascalstr. 8 47506 Neukirchen-Vluyn...
- Page 6 Simac GmbH, Pascalstr. 8, D-47506 Neukirchen-Vluyn, Germany Possibility of return in your area: We will send you a parcel stamp with which you can return the device to us free of charge. Please contact us by e-mail at Service@joy-it.net or by telephone. Information on packaging: If you do not have suitable packaging material or do not wish to use your own, please contact us and we will send you suitable packaging.
Need help?
Do you have a question about the RB-LCD-7P4-Case and is the answer not in the manual?
Questions and answers