User’s Manual SP226 1 General information 1.1 About this manual This manual describes the installation, function and operation of an integrated solar pumping station, which is suitable for split pressurized solar heating system. Before installing and operating the device, please read the following information carefully.
Page 3
User’s Manual SP226 2 Product information System description The solar collector pump (P1) is activated as soon as the temperature difference between the collector array (T1) and the storage tank (T2) is reached. If the temperature difference between the collector array (T1) and storage tank (T2) drops below the switch-off temperature difference, or the storage tank (T3) reaches the maximum storage temperature, the solar pump (P1) will be switched off.
User’s Manual SP226 2.2 Single-pipeline solar station: SP116 2.2.1 Components Operating screen Manometer Pump speed regulation WILO pump Input connector Security valve Expansion vessel connector Output connector Mounting point 2.2.2 Installation description SP116 should be installed in return flow of the solar circuit, as indicated above. Please see detailed installation...
T1~T3 (top part of water tank; bottom part of water tank; solar collector) Output signals 3 (auxiliary heating; solar collector pump; solar circulation pump) Double-pipeline solar station: SP226 2.3.1 Components Filling und flushing connecting Operation screen Pump speed regulation WILO pump...
Page 6
User’s Manual SP226 2.3.2 Installation description SP226 should be installed in forward flow (manometer side) and return flow (pump side) of the solar circuit, as indicated above. Please see detailed installation instruction in attached manual. 2.3.3 Technical data Rated voltage...
Time-controlled auxiliary heating. Setting three heating time periods. Time-controlled hot water circulation. Setting three time periods. Tank temperature. As turning-on/off temperature value for auxiliary heating. Solar system indication. For SP116/SP226, only 1 system available. Frost protection signal. Overheating protection for storage tank.
User’s Manual SP226 Functions and operation Danger: Before connecting the power supply, make sure that the water tank, solar collector, solar pumping station and all temperature sensors are good connected! Note: For safety, auxiliary heating is locked at delivery state. The single “...
Page 9
User’s Manual SP226 Note: Between 60~70℃ scale can form more easily, we usually set the water tank temperature at 60℃. 3.3 Time-controlled circulation function This function needs an extra circulation pump (P2). You can set up a timer program with up to three time periods.
Page 10
User’s Manual SP226 ì Immediately after setting the first time period, the display enters into the operating menu of next time period. ì Perform like above steps, the other two time periods can be set. Note: If you want to shut off one of the three time periods, you can set a same value for both start time and end time, e.g., you can set both the start and end time of second time period at 10:00 am.
User’s Manual SP226 3.8 Frost protection In winter, when the temperature of collector drops below the preprogrammed starting temperature of frost protection (default value 5℃), solar pump P1 starts working. When collector temperature exceeds the switch-off temperature of frost protection, pump P1 stops working and the system exits frost protection.
User’s Manual SP226 3.12 Collector emergency cut-off When the temperature of collector reaches or exceeds 120℃, in order to prevent evaporation of heat medium liquid and protect other components of solar system, solar circulation pump will be stopped compulsively, until the temperature of collector gets lower.
The solar pumping station SP116/SP226 shows error messages in the main operating menu if there is a problem with temperature sensor. Error message meaning Possible cause Error rectification...