Connecting The Ifp Usb-Port; Connecting A Source Device - ViewSonic myViewBoard Direct User Manual

2. Getting Started
Warning: For your safety and the safety of your device, do not connect to a power
supply before and during the setup of the external device.

Connecting the IFP USB-port

Connecting a source device

To connect the myViewBoard Direct to the IFP display (OPS) serial USB-port:
1. Secure myViewBoard Direct first using the shared IFP display (OPS) backplane
screw.
2. Use the supplied USB cable to connect myViewBoard Direct to the IFP display:
a. Connect one end of the USB cable (Micro B) to myViewBoard Direct.
b. Connect the other end of the USB cable (Type A) to the IFP display (OPS)
USB-port.
3. Use an HDMI cable to connect myViewBoard Direct with HDMI devices.
a. Connect one end to the HDMI output port of the video device.
b. Connect the other end of the cable to the HDMI input port of myViewBoard
Direct.
4. For better image quality, connect to a USB 3.0 port.
See the list below for reference:
• USB 2.0: up to 480Mbps (60MB/s) (MJPG)
• USB 3.0: up to 5Gbps (625MB/s) (MJPG/YUY2)
Higher speeds mean better quality.
3