ENGLISH Product Description Thank you for purchase and use LD-101 manual breast bump. The manual breast pump is used to express and collect breast milk from lactating mothers. Please read this manual carefully before using stimulation and expression mode. This is a single use product that should not be shared between moms.
ENGLISH Installation Instructions Product Assembly Note: Make sure you have cleaned and optionally disinfected the appropriate parts of the breast pump. After cleaning, follow these steps to assemble your collection units: Step 1: Insert the breastshield into the funnel-shaped section of the pump body. Two breastshield sizes are available:24mm and 27mm.
Page 6
ENGLISH Step 2: Please install the white membrane on valve smoothly. Make sure the white membrane won’t curl up. Step 3: Insert the valve into the pump body from un- derneath. Push the valve in as far as possible. Step 4: Screw the pump body clockwise onto the bot- tle until it is securely fixed.
Page 7
ENGLISH Step 5: Insert the stem into the hole of the elastic diaghragm. Push the stem in as far as possible. Place the diaphragm with stem into the seal seat, make sure the diagh- ragm edge and seal seat edge close fitting. If there’s no “O” shaped sealing ring on the plug at the bottom of the sealing seat, please put in on.
ENGLISH Step 7: Insert the seal seat in the hole of the connec- tor and screw the seal seal clockwise until it is securely fixed. Pumping Relax in a comfortable chair (you may wish to use cushions to support your back). Press the assembled pump body against your breast.
ENGLISH Do not continue pumping for more than 5 minutes at a time if you do not succeed in expressing any milk. Use bottle holder to prevent the bottle from tipping over. Do not fill the bottle too full to o prevent overfilling and spillage.
ENGLISH Cleaning Caution 1. Clean and sanitize the parts below before using your pump for the first time. 2. Only use drinking-quality tap or bottled water for cleaning. 3. Take apart and wash all parts that come in contact with the breast and breastmilk immediately before and after use to avoid dry up of milk residues and to prevent growth of bacteria.
ENGLISH Trouble Shooting Abnormal phenomenon Cause analysis Solutions Inspect all connection points to Connection points is loose ensure attachment is secure Low or No Suction The valve is chipped or Replace valve and/or membrane cracked or there’s holes or prior to pumping tears on membrane is Replace a appropriate size Breastshield size is not fit...
(warnings) ative in the European complies with carefully community Directive 93/42/EEC Keep away from Manufacturer Serial number sunlight Consult instructions Product code Lot number for use Temperature limit Humidity limit GIMA WARRANTY TERMS The Gima 12-month standard B2B warranty applies.
Need help?
Do you have a question about the LD-101 and is the answer not in the manual?
Questions and answers