Do you have a question about the BON-II Series and is the answer not in the manual?
Questions and answers
Summary of Contents for Apro BON-II Series
Page 1
2.5” SATA III MLC SSD Supports Fast & Secure Erase BON-II Series Product Specification APRO RUGGED METAL 2.5” SATA III MLC SSD SUPPORTS FAST / SECURE ERASE Version 01V1 Document No. 100-xR2SRBON-JHTM April 2015 APRO CO., LTD. Phone: +88628226-1539 Fax: +88628226-1389...
Page 2
This document is for information use only and is subject to change without prior notice. APRO Co., Ltd. assumes no responsibility for any errors that may appear in this document, nor for incidental or consequential damages resulting from the furnishing, performance or use of this material.
1. Introduction APRO MLC rugged metal 2.5” SATA III SSD – BON-II series provides high capacity flash memory Solid State Drive (SSD) that electrically complies with Serial ATA 3.0 (SATA) standard. APRO Rugged Metal 2.5” SATA III MLC SSD – BON-II Series support SATA Gen-III (6.0 GB/s) with high performance.
1.3. In order to gain the best management for flash memory, APRO 2.5” SATA III MLC SSD BON-II Series supports Static Wear-leveling technology to manage the Flash system. The life of flash memory is limited; the management is to increase the life of the flash product.
Data Retention Physical Specifications 2.5. Refer to Table 5 and see Figure 2 for Rugged Metal 2.5” SATA III MLC SSD BON-II Series physical specifications and dimensions. Table 5: Physical Specifications of APRO Rugged Metal 2.5” SATA III MLC SSD-BON-II Series 99.70 mm / 4.0 in...
APRO Rugged Metal 2.5” SATA III MLC SSD interface 3.1. APRO Rugged Metal 2.5” SATA III MLC SSD is equipped with standard 7 pins + 15 pins Serial ATA connector. Figure 3 :The connectors of 2.5” SATA III MLC SSD APRO Rugged Metal 2.5”...
Fast / Secure Erase Jumper 4.1. BON-II Series 2.5” SATA III SSD has several security features, such as fast erase, secure erase and a newly added write-protect function. These functions can be triggered by different hardware jumper settings or by ATA commands.
4.1.3. Fast Erase Procedure is one of the default sanitizing procedure in APRO Secure Erase SSD Series, it is trigger by placing jumper head on Pin-7 and Pin-8, SSD will be then become fully erased and filled with 0xFF and random data.
The protection mechanism only allows customer to activate Fast Erase and Secure Erase once for each power-on cycle. This is to protect APRO’s SSD from being erased continuously and can indirectly extend the lifetime of flash. If user wishes to activate erase function again, power must be disconnect and then reconnect again.
In no event shall APRO be liable for any lost profits, lost savings or other incidental or consequential damages arising out of the use of, or inability to use, this product.
Need help?
Do you have a question about the BON-II Series and is the answer not in the manual?
Questions and answers