TSG Albert EFTPOS How-To Manual

Charging Albert

With a dock
1. Connect the charging cable to the dock.
2. Place Albert on the dock.
Without a dock
1. Remove the power outlet cover on the
left side of the device.
2. Connect the charging cable to the power
outlet.
Technical Services Group Pty Ltd

Changing a receipt roll

1. Open the printer door by sliding the
button on the left. The door will pop
down.
2. Remove the empty roll and any leftover
paper.
3. Prepare the new roll by loosening the end
of the strip.
4. Drop the new roll into the compartment.
Make sure the end of the strip of paper
feeds over the roll and above the door.
5. Close the door by pressing it towards
Albert. When closed properly it will click
into place.
Albert EFTPOS Terminal: How to Guide

Powering Albert

Switch on - Press and hold the Power button to
switch on Albert.
Wake up – If Albert is switched on but the screen is
blank, press the Power button once.
Switch off – Press and hold the button until the
prompt appears.

First login

Once albert has booted for the first time you will
need to swipe the screen to begin. There will be
prompt for the "Password" enter the password to
continue.
1