Advertisement
Table of Contents
MTI M200-RS Development Kit
Quick Start Guide
Introduction
This document describes how to start reading UHF RFID tags with the MTI M200-
RS pin-to-pin, 100% compatible module for Indy® RS2000 Development Kit.
Kit Contents
• RS2000 Development Board
• Kit Quick Start Guide
• USB drive containing software tools and
documentation
• Impinj Mini-Guardrail Antenna
• Laird Far Field Antenna
Getting Started with the M200-RS Development Kit
1. Install the Indy Demo Tool software on your Windows PC.
Indy Demo Tool.exe
a. Copy the
2. Configure the M200-RS development kit hardware as shown in
a. If you have reconfigured the jumpers since opening the kit, restore the default configuration as described in
the "Kit Default Configuration" section of the
b. Connect the kit PCB to your PC using the Mini-USB cable.
c. Connect the 12 Volt DC power supply to a power source, and the kit PCB
At this point, the green "Health" LED on the right edge of the kit PCB should start blinking.
i.
d. Connect the ANT1 port (J201) on the kit PCB to the Mini-Guardrail antenna using the SMA RF Cable.
e. Place one of the UHF RFID tags on top of the antenna.
770-00008 Revision 1.1, Copyright © 2020, Impinj, Inc.
Revision 1.2 Copyright © 2020, Microelectronics Technology, Inc.
• 12 Volt DC Power Supply
• SMA RF Cable
• Mini-USB Cable
• RAIN RFID Tag Samples
• M200-RS Module Samples (2)
file from the USB drive.
Figure
M200-RS Hardware User's
1.
Guide.
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for MTI M200-RS
Summary of Contents for MTI M200-RS
- Page 1 MTI M200-RS Development Kit Quick Start Guide Introduction This document describes how to start reading UHF RFID tags with the MTI M200- RS pin-to-pin, 100% compatible module for Indy® RS2000 Development Kit. Kit Contents • RS2000 Development Board • 12 Volt DC Power Supply •...
- Page 2 MTI M200-RS Development Kit Quick Start Guide Figure 1 – RS2000 Development Kit Hardware Configuration 3. Start performing tag reads as shown in Figure a. Open the Indy Demo Tool software by double-clicking on the “Indy Demo Tool.exe” file. b. Press the “Scan” button to detect the COM port corresponding to the development board.
- Page 3 MTI M200-RS Development Kit Quick Start Guide Figure 2 – Indy Demo Tool GUI Configuration 4. Read through the more detailed documentation associated with the part and kit, including the M200-RS Datasheet, M200-RS Hardware User Guide, and M200-RS IRI Toolkit User Guide.
Need help?
Do you have a question about the M200-RS and is the answer not in the manual?
Questions and answers