Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for hortiONE 368
Summary of Contents for hortiONE 368
- Page 1 368 & 592 Manual hortiONE 368 hortiONE 592 hortiONE GmbH...
- Page 2 Attaching the mounting brackets ............................4 Electrical Connection ................................4 Technical Specification - Dimensions ............................. 5 LED-Driver MEANWELL HLG 185 – 193W – for hortiONE 592 ..................... 5 LED-Board hortiONE 592..............................5 LED-Driver Inventronics – 130W– for hortiONE 368 ......................5 LED-Board hortiONE 368 ..............................
- Page 3 Introduction Thank you for purchasing a hortiONE 368 / 592 LED grow light. This manual explains how to install, run and maintain your grow light. Mounting and installing of the LED fixture may be executed by certified service personnel only. Please read and understand this manual completely before using the product.
- Page 4 Scope of application hortiONE LED lamps are designed for horticultural applications only. hortiONE 592 & 368 is only suitable for indoor environments. The Light is suitable for all land-plants (no Algae) and all growing phases. Vegetative and generative growth as well as hibernation and seedlings.
- Page 5 592 & 368 manual, 2019 Installation and assembly Attaching the mounting brackets Insert the hanger into the first hole and move it down until the other side of the hanger reaches the second hole 2. Push down the other side of the hanger inside the hole 3.
- Page 6 592 & 368 manual, 2019 Technical Specification - Dimensions LED-Driver MEANWELL HLG LED-Board hortiONE 592 185 – 193W – for hortiONE 592 Meanwell Datasheet: https://www.meanwell.com/webapp/product/search.aspx?prod=HLG-185H LED-Driver Inventronics – 130W– LED-Board hortiONE 368 for hortiONE 368 Inventronics product-Information and Datasheet: https://www.inventronics-co.com/product/eum-150sxxxdg/...
- Page 7 Kindly note that a separate (not shown) measurement Unit is needed. Only change the electricity [I]. The LED Driver for HO 368 (Inventronics) supports different dimming-modes: 1-5V, 1-10V, PWM, Multiple Timers The use of a potentiometer is sufficient. Even if the signal comes via PWM (pulse width modulation), it is regulated internally to 0-10V.
- Page 8 592 & 368 manual, 2019 Cleaning instructions Ideally, cleaning by means of oil-free air (e.g. central supply or spray can) is recommended. The LEDs or the board are blasted with clean air. If compressed air from a central supply is used, purified air must be used. Otherwise, contaminants like outs may be sprayed onto the board.
Need help?
Do you have a question about the 368 and is the answer not in the manual?
Questions and answers