Installing The Front And Back Covers - Hardlife Utility 122008R Instruction Manual

NOTE:
Ensure that the horizontal connecting tubes are below the arch of the frame so that the roof cover can be well
supported, as shown in Figure 4.
5. Likewise, install the other arches in the same manner and connect them using the male horizontal con-
necting tubes.
6. Install the back door arch and connect using the male horizontal connecting tubes.
7. Finally, plug the connecting tubes with their respective ø42 mm plastic plugs (component code 18) or ø28
mm plastic plugs (component code 19).
8. Tighten all the frame bolts and connecting tubes adequately before installing the roof cover.

INSTALLING THE FRONT AND BACK COVERS

CAUTION:
Do not install the front and back covers onto the frame of the carport in high wind conditions.
1. Put on the front door cover (component code 14) from the inside of the front door frame to the outside,
as shown in Figure 5.
9
Figure 4
www.hardlifeutility.com