Table of Contents
Advertisement
Remove the fridge door by gently pulling
downwards and store to avoid damage.
Unscrew the top door hinge pin of the refrigerator
then screw it back on the other side. As shown in
the second drawing.
Replace the fridge door on the upper door hinge
pin.
Insert the lower door hinge pin into the door and
tighten all screws.
Re-fix the retained screw to the bottom right hand
side and replace the 2 adjustable feet.
Lift the fridge back onto its feet and check it is set
level and the door seal meets the fridge all around
the door.
Transfer the handle to the opposite side and place
the plastic covering inserts, (supplied in the plastic
bag of this instruction book) into the holes set free.
Reconnect the fridge to the electricity supply.
Any electrical work required to install this
appliance should be carried out by a
qualified electrician or competent person.
This appliance must be earthed.
The manufacturer declines any liability should
these safety measures not be observed.
Electrical Requirements
Before switching on, make sure the electricity supply
voltage is the same as that indicated on the appliance
rating plate.
The appliance is supplied with a 13 amp plug fitted. In
the event of having to change the fuse in the plug
supplied, a 13 amp ASTA approved (BS 1362) fuse
must be used. Should the plug need to be replaced
16
Electrical Connection
Electrical Connection
Advertisement
Table of Contents
