Halotherapy Solutions HaloGX Mobile Instructions

HaloGX Mobile Instructions
(It is strongly recommended that the video for this product is also viewed)
Location of equipment:
The humidity level in the room must be lower than 65%. A dehumidifier can be used to
lower the humidity in the room. If humidity is higher, salt will not rise and will stick to the
tube's walls.
Preparing:
1.Remove the transportation bolt (see
for the protection of the halogenarator when it is being shipped.
2. Plug the transformer into the halogenerator( green light on the Stop button will light up)
Starting:
1. Remove the Fan part on top of the transparent tube by opening connection nut which is
holding fan part on top of the transparent tube).
2. Put 1 tablespoon of dry salt (you may want to warm up the salt in a crockpot first to
remove any/most moisture from the salt) into the transparent tube. (if this is for business
use this should last 1 full day of clients)
3. Fit the Fan part back on top of tube.
Now halogenerator is ready for use (There is no main on/off switch).
5. Press START . ( if halgenerator has not been used for a long tim , press start 2 times )
To see that it is working, numbers on display will blink after every second until the session
ends.
Using Turbo button:
While the non-turbo mode is best for the effects of halotherapy, many people want to
see/taste the salt, so we have created this turbo feature. Salt will blast out for 2 seconds
every 2 minutes. Press the white switch in the middle of the halogenerator front panel.
To stop the turbo function, just press it again and it will switch off.
How to change settings:
Press SET one time , green LED #1 light up
Now you can adjust session time by +/- from 1......99min 20 minutes is recommended
Press SET second time green LED #2 will light up
https://youtu.be/QzxpNTKkYf0
I ), This bolt is only