Bungard NE-CUT Instructions For Use Manual

Instructions for use
Application
NE-CUT is suitable for boards up to a width
of 530 mm. The maximum thickness of the
board depends on the material you want to
cut. You can cut FR4 up to 3 mm, aluminium
depending on the alloy up to 2 mm and
sheet steel depending on the alloy up to 1.0
mm.
The cut has to be done in one stroke by a
normal strong man. A mechanical or electric-
al aid like a lever or a motor is not allowed.
This might damage the board cutter irrepar-
able.
The thinnest material you can cut is 0,1 mm
(new board cutter or just sharpened blades
assumed). This enables the cutter even to
cut film material, clichés etc..
Bungard Elektronik GmbH & Co. KG, Rilkestraße 1, 51570 Windeck – Germany
Tel.: +49 (0) 2292/5036, Fax: +49 (0) 2292/6175, E-mail: support@bungard.de
NE-CUT
Board Cutter
Features:
Cutting width max. 530 mm
•
Two knifes made of hardened and
•
ground steel
Spring loaded built-in clamping unit in
•
the front
Transparent cover hood for user safety
•
and visual control
Metric edge scales in the front
•
Fully adjustable back stop with metric
•
scale for batch work (0...300 mm)
Smallest cutting size (front) 45 mm
•
Durable full steel construction
•
All important parts angular adjustable
•
Simple exchange of blades
•
Adjustable cutting angle
•
Adjustable clearance
•
Technical Datas
Dimension (W x H x D):
•
74 cm x 29 cm x 45 cm
Weight::
•
66 kg
Security
All dangerous parts are covered as far as
technically possible and reasonable.
gap between table and downholder is only 5
mm, so it is almost impossible to get your
hand into the blade while the downholder is
mounted.
The only source of danger is behind the ma-
chine. Never pull the lever while you or any-
body else is working behind the machine.
Especially when somebody is trying to re-
move the cut boards from behind the ma-
chine.
Always were cut proof gloves when handling
the blades. Secure the loose blades from
being touched or from falling down.
page 1 / 6
The