Descriptions - B-52 MATRIX 1000 Instruction Manual

DESCRIPTIONS

1. AMPLIFIER: The Matrix 1000 subwoofer amplifier
panel.
2. LEFT SPEAKER OUTPUT: Speakon connector output
for left monitor.
3. COOLING FANS: Rear cooling fans for built-in
subwoofer amplifier. Ensure these cooling fans are
clear of external obstructions for efficient operation.
4. WARNING INFORMATION. Please read and
adhere to these instructions to ensure safe
operation.
5. POWER CORD CONNECTOR: For attachment of
the included power cord.
6. FUSE HOLDER: Contains primary 6A fuse.
7. POWER ON/OFF SWITCH: Turns the Matrix 1000
on and off.
8. RIGHT SPEAKER OUTPUT: Speakon connector
output for right monitor.
9. PHASE SWITCH: Sets the polarity of the Matrix
1000.
10. SUBWOOFER GAIN CONTROL: Controls the levels
of Gain to the subwoofer.
11. GROUND/LIFT SWITCH: Remove ground from
circuit to eliminate excessive 60-cycle hum.
12. RIGHT MONITOR GAIN CONTROL: Controls the
levels of Gain to the right side full range speaker.
13. XLR BALANCED RIGHT FULL-RANGE OUTPUT:
Sends parallel full range signal out to other systems
or components.
14. XLR BALANCED RIGHT FULL-RANGE INPUT:
Connects the right side full range speaker to your
mixing console.
15. LEFT MONITOR GAIN CONTROL: Controls the
levels of Gain to the left side full range speaker.
16. XLR BALANCED LEFT FULL-RANGE OUTPUT:
Sends parallel full range signal out to other systems
or components.
17. XLR BALANCED
Connects the left side full range speaker to your
mixing console.
18. LEFT CHANNEL CONTROLS
19. RIGHT CHANNEL CONTROLS
4
LEFT FULL-RANGE
1
NOTE: Use Pin #:
1+ and 1-
3
4
INPUT:
2
17