Advertisement
Quick Links
Original-Instruction manual
Art.-No.: 810 010
Professional
Brake Piston Reset Tool set
12-pcs.
Example picture
Bendel Werkzeuge GmbH & Co. KG
Wilhelm-Schulze Str. 8-10
29549 Bad Bevensen
www.bendel.de
All rights reserved. Technical changes and changes of pictures can always occur.
1
Ver. 2004-01
Advertisement
Related Manuals for BENDEL 810 010
Summary of Contents for BENDEL 810 010
- Page 1 Original-Instruction manual Art.-No.: 810 010 Professional Brake Piston Reset Tool set 12-pcs. Example picture Bendel Werkzeuge GmbH & Co. KG Wilhelm-Schulze Str. 8-10 29549 Bad Bevensen www.bendel.de All rights reserved. Technical changes and changes of pictures can always occur. Ver. 2004-01...
- Page 2 General safety information Please read this manual in detail before the first use and don’t throw away this manual. Share the manual with other users or give it along to a new user. The manufacturer is not liable for personal injury and property damage due to wrong usage or other usage than mentioned in this manual.
- Page 3 Application for floating calipers 1. Insert the ¼ “extension (F) from behind into the plastic cap at the rear end of the brake piston tool (A) and push the extension through the entire tool. 2. Take a feed spring (H) from the tool case and slide it over the ¼...
- Page 4 Push the release lever of the tool forward in the direction of the arrow and push the magnetic adapter (E) flush to the retaining plate. Position the retaining plate between the brake piston and the saddle frame. 7. Thread the pins of the pin adapter into the recesses of the brake piston and clamp the reset between the brake piston and the saddle frame by lifting movements on the lifting calliper (A) until the feed...
- Page 5 Application for firm and fixed calipers: 1. Position the front pressure plate (C) and the rear pressure plate (B) between the brake piston and the caliper frame. 2. Make sure that the pressure plates ((B) + (C)) do not tilt and do not damage the sleeves. 3.
- Page 6 7. Position the front and rear pressure plate between the brake pistons and the caliper frame and push the brake pistons back with slight lifting movements. 8. Push the release lever forwards in the direction of the arrow, relax the brake piston tool and pull it out of the brake caliper.
-
Page 7: Scope Of Delivery
Scope of delivery (A) Lifting pliers with pre-assembled retaining plates (B) Rear pressure plate (C) Front pressure plate (D) ¼“ extention (with ¼” square drive) (E) Magnet adapter for pin-Adapter (F) Adapter pressure plates (2 pcs.) 100mm, with magnet (G) Adapter- pressure plates (2 pcs.) 175mm, with magnet (H) Feed springs (2 pcs.) (I) Tool case... - Page 8 No liability for printing errors, subject to change. ©Copyright Bendel Werkzeuge GmbH & Co. KG Wilhelm-Schulze Str. 8-10 29549 Bad Bevensen Tel. +49(0)5821 – 9897-0 / Fax. +49(0)9897 – 20 www.bendel.de info@bendel.de Ver. 2004-01...