Page 1
IP65 specification only. In combination with the following linear lighting profiles: • PWR-05500 • PWR-05500-B Magnus For further information of applicable profiles, see section 3 of this manual. Joris Justin Manual Veko linear lighting system / IP65 / V04 / 2020-09-29 1/16...
Page 2
Single unit (re-) placement Sensor MD-L (re-) placement 11, 12 Sensor configuration(s) Pool Emergency LED indicator & battery replacement Emergency system info & disclaimers General disclaimers Manual Veko linear lighting system / IP65 / V04 / 2020-09-29 / Table of contents 2/16...
Page 3
Always use a suspension with at least 3 points. Note: measurement F is half of measurement E, deviding E equally over 2 lineparts. Manual Veko linear lighting system / IP65 / V04 / 2020-09-29 / Mounting 3/16...
Page 4
11 Close the link of the KDW-hook. center of the profile. 12 Example of mounting with threaded end. 8 Example with KDW-hook, pendula and steel- 13 Example of mounting with caddy. Manual Veko linear lighting system / IP65 / V04 / 2020-09-29 / Mounting 4/16...
Page 5
11 Rotate the plate into position. tend the flatcable. 7 Make sure connectors firmly 'click' into each- 12 Tighten the slotted M6 bolts (4x). Manual Veko linear lighting system / IP65 / V04 / 2020-09-29 / Coupling 5/16...
Page 6
Overview of mounting brackets and couplings IP65 Coupling Profile Mounting Note: Applicability of bracket may vary, depending on the surrounding, light-line configuration, light-line application and/ or IP-class. Manual Veko linear lighting system / IP65 / V04 / 2020-09-29 / Bracket overview 6/16...
Page 7
5 Fit the cable gland(s). 10 Tighten the M5 hexagon bolts on both sides- switch the mains back on. Manual Veko linear lighting system / IP65 / V04 / 2020-09-29 / Power feed with Cable gland 7/16...
Page 8
4 Connectors should firmly 'click' into eachother. 7 Rotate the plate into position. 8 Tighten the M6 bolts (4x). Manual Veko linear lighting system / IP65 / V04 / 2020-09-29 / Power feed Wieland 8/16...
Page 9
4 Press and mount the fallout safety clip into- of a single unit or blindplate. properly inside the linear lighting system. Manual Veko linear lighting system / IP65 / V04 / 2020-09-29 / Single unit (re-) placement 9/16...
Page 10
7 In case of the narrow lens, a cover 9 Sensor reach: position. can be used to limit the reach of the MD-L-R (round lens) sensor beam if necessary. MD-L-Na (narrow lens) Manual Veko linear lighting system / IP65 / V04 / 2020-09-29 / Sensor (re-) placement 10/16...
Page 11
IP65 When the Veko Advanced Relay sensor is plugged into the light-line and connected to power, it will fully function and perform as a motion detection sensor. All Veko sensors have a standard configuration. Some of these features are manual adjustable with a remote control (TR67).
Page 12
IP65 When the Veko Advanced Relay sensor is plugged into the light line and connected to power, it will fully function and perform as a motion detection sensor. All Veko sensors have a standard configuration. Some of these features are manual adjustable with a remote control (TR67).
Page 13
NEN-EN 60598-2-22 Lighting fixtures - Part 2-22: Particular requirements for emergency lighting fixtures; • NPR 9200 Metal suspension structures and fasteners in swimming pools. Applicable products Profiles Mounting Coupling Suspension Manual Veko linear lighting system / IP65 / V04 / 2020-09-29 / Pool 13/16...
Page 14
5 Disconnect the mains before operating wires with the emergency module. Replace emergency the linear lighting system. unit as described in section 6 of this manual. Manual Veko linear lighting system / IP65 / V04 / 2020-09-29 / Emergency LED indicator & Battery replacement 14/16...
Page 15
- Batteries are fully charged; - A system error had occured, see also the overview table in section 2 of this manual. Manual Veko linear lighting system / IP65 / V04 / 2020-09-29 / Emergency system info & disclaimers 15/16...
Page 16
NEN 1010 and NEN 3140. Note - A Veko linear lighting system is considered as a single luminaire (a 'closed' system) and not an electrical installation at itself. - The light source of this product is custom made and shall only be replaced by the manufacturer or his service agent.