TE Connectivity HTP600 Quick Start Up Manual

Download Printer Driver and
Software on Te Server

Step 1: Driver Installation

®
For Windows 7, 8, 10 (32 and 64 bit)
Notice:
• Turn The HTP600 Off
• The printer must not be connected to the PC.
• Unplug the USB cable from the printer
Driver Installation
• Select the sub-folder \HTP600-Printer
Drivers
• Execute Setup Program
• Select English
• Press Install
• Check the Printer is Turned off or disconnected
• Press Install to Continue
Printer HTP600 Quick Startup Guide 200707-English
HTP600 Quick Startup Guide
The installation proceeds, it can take a few
minutes.
•
Press "Install this Driver software anyway"
• A Restart of the PC is requested.
Notice:
For Automatic Plug and Play HTP600 Printer
• Restart the PC
• Insert Strong-Black ribbon
• Plug the USB cable on the computer
• Turn HTP600 On
• Wait until HTP600 must be ON LINE
After a few seconds a "new hardware
found" message appears.
The P-PRINTER is detected and added.
• From Start
• Select "Settings"
• Select "Devices"
• Select
The "P-PRINTER" appears:
Step 2: Automatic Creation of
7 Printer Devices in Windows
Notice:
• The HTP600 Installation requires the creation of
7 different Printer Devices.
• The creation process is Automatic
• Select the sub-folder \HTP600-Printer Drivers
• Select the sub-folder \ENG
• Select the sub folder \HTP600 COPY DRIVER ENG
• Execute program \PPRCOPY.exe
• Execute PPRCOPY.exe
• Press Ok to proceed
• Press Ok to Complete the Printers Installation
1/4