Fitting Under A Counter; Technical Specifications - Zanussi DA 6141 D Instruction Book

Fitting under a counter

(kitchen worktop or sink)
By removing the machine's worktop, you can install it under a
close fitting sink unit or a pre-existing top, providing the
dimensions of the recess correspond to those shown in the
picture.
Proceed as follows:
Remove the machine's worktop by unscrewing the two rear
retaining screws, pull from the front and slide out the rear
slots, lifting the worktop.
Insert the machine after adjusting height and levelling with the
adjustable feet. When inserting the machine, ensure that the
water inlet and drain hoses are not kinked or squashed.
If the dishwasher is later used as a free-standing appliance,
the original worktop must be re-mounted.
The plinth on free-standing appliances is not adjustable.

Technical specifications

Dimensions
Electrical connection:
Voltage
Overall power
Fuse
Water supply connection:
Water supply pressure:
Capacity
This appliance complies with the following E.E.C. Directives:
- 73/23 or 19.2.73 (Low Voltage Directive) and subsequent modifications;
- 89/336 or 3.5.89 (Electromagnetic Compatibility Directive) and subsequent modifications.
IN05
Width
Height with worktop
Height without worktop
Max depth
Information on the electrical connection is given on the rating plate on the
inner edge of the dishwasher's door on the right.
Maximum
Maximum
Levelling
Good levelling is essential for correct closure and sealing of
the door.
When the appliance is correctly levelled, the door will not catch
on either side of the cabinet.
If the door does not close correctly, loosen or tighten the
adjustable feet until the machine is perfectly level.
7
60 cm
85 cm
82 cm
63.5 cm
cold water
50 kPa (0.5 bar)
800 kPa (8 bar)
12 place settings