Fitting Under A Counter; Technical Specifications - Zanussi DA 4131 Instruction Book

Fitting under a counter

(kitchen worktop or sink)
By removing the machine's worktop, you can install it under a
close fitting sink unit or a pre-existing top, providing the
dimensions of the recess correspond to those shown in the
picture.
Proceed as follows:
- Remove the machine's worktop by unscrewing the two
front retaining screws, pull from the front and slide out the
rear slots, lifting the worktop.
Insert the machine after adjusting height and levelling with the
adjustable feet. When inserting the machine, ensure that the
water inlet and drain hoses are not kinked or squashed.

Technical specifications

Dimensions
Electrical connection:
Voltage
Overall power
Fuse
Water supply pressure
Capacity
This appliance complies with the following E.E.C. Directives:
- 73/23 or 19.2.73 (Low Voltage Directive) and subsequent modifications;
- 89/336 or 3.5.89 (Electromagnetic Compatibility Directive) and subsequent modifications.
For best results we recommend the use of Finish detergents, rinse aid and salt.
DE15
IN04
Width
Height with worktop
Height without worktop
Max depth
Max depth with open door
Information on the electrical connection is given on the rating plate on the
inner edge of the dishwasher's door.
Minimum
Maximum
L I Q U I D G E L
Levelling
Good levelling is essential for correct closure and sealing of
the door. When the appliance is correctly levelled, the door will
not catch on the levelling spacers on either side of the cabinet.
If the door does not close correctly, loosen or tighten the
adjustable feet until the machine is perfectly level.
EASY
POURING
PACK
P O W D E R
C O N C E N T R AT E D D I S H WA S H E R D E T E R G E N T
5
115.9 cm
50 kPa (0.5 bar)
800 kPa (8 bar)
8 place settings
FOR A
BRILLIANT
SHINE
R I N S E
45 cm
85 cm
82 cm
63 cm