Advertisement
Vehicle Port
J1708 Deutsch (6-pin)
OBDII with CAN Support
Found in certain models of Volvo and
Mack vehicles, this port supports the CAN
bus connectivity through a 16-pin OBDII
port.
RP 1226 (14-pin)
The RP 1226 is a newer connector
designed specifically for ELD use. It may
be found in trucks with model year 2018
and later.
rev 2020.08.05
Page 7 of 11
J1708 Y-Cable
A Y-cable is available for connecting the 66xx to vehicles supporting this port type.
Please note that this cable is incompatible with beacon model 6681.
OBDII Single Wire or Y-Cable
The OBDII power/data connector is available as a single wire or Y-cable.
Warning: Some electric vehicles are equipped with two OBDII-style ports. One is
the EV port used by the manufacturer for firmware updates, and the other is the
OBDII diagnostic port used for the 66xx. Connecting the 66xx to the EV port may
damage the vehicle. Check your vehicle documentation to correctly identify the
ports.
RP 1226 Single Wire Cable
The RP 1226 power/data connector is only available as a single wire.
*Please note that this cable has not been fully tested with beacon model 6681 and
may be incompatible.
installation guide
installation guide
Nero 66xx Beacon Family
Available Power Cable
© 2020 Vecima Networks Inc. All rights reserved.
www.neroglobal.com
Advertisement
