Advertisement
Section II •
iFIT Prosthesis Component Guide
Please use this guide in any communications regarding your prosthe-
sis. This will help the prosthetist and the manufacturing company when
responding to any questions you may have.
Socket
Pyramid adapter
with hole
Pylon clamp
adapter
Pylon with
bonded adapter
Safety
latches
Buckle
10
Padded Liner
Cable Guide
Cable Hook
Cup
Release button for
pin suspension
Section III •
Instructions
STEP A: INITIAL DEVICE CHECK
1) It is important to check your
device every day prior to putting it
on. No screws should be loose, and
there should be two cables along
the back.
2) When checking the silicone locking
liner (with pin), always make sure the
pin is secured and not loose. This liner
should be rolled onto the residual limb
without any gaps or air bubbles at the
end. Make sure the pin sticks out direct-
ly below the limb and that it is not angled
in one direction.
3) The prosthesis liner should be
securely placed in the prosthetic
socket, with the liner reaching the
bottom of the socket. Make sure the
liner is not wrinkled or folded down
into the prosthesis.
4) The outer flap of the prosthesis
should have the cable guides with
the cables passing through it and
attaching to the hooks. The inner
flap is smooth and slides under the
outer flap.
11
Advertisement
