PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLATION
IMPORTANT INSTALLATION INFORMATION
1.Before commencing installation or maintenance, ensure
electricity is switched off at the mains. Installation or
maintenance should be carried out by a qualified electrician.
2.The luminaire must not, under any circumstances, be
installed directly to flammable materials, and luminaires
must not be covered with any flammable materials.
3.Mounting height range of 3 meters to 6 meters, this model is
suitable for outdoor lighting.
4.Ensure there is adequate free air circulation of at least
50cm around the luminaire. All luminaires run hot. It is
the installer's responsibility to consider fire risk and take
appropriate precautions.
LEAVE A COPY FOR THE USER / MAINTENANCE ENGINEER
FOR FUTURE REFERENCE
Installation Instruction & Installation Steps
1
STEP 1:
1.Loosen the M10 screws, nuts, spring washers on the spigot with a wrench.
2.Insert the pole into the middle hole of spigot till to the end.
3
Locking bolts
STEP 2:
1. Loosen locking bolts and open the cover.
5
Locking bolts
STEP 5:
1. Fasten the locking bolts on the cover tightly.
Screw
Spring washer
Nut
Pole
Cover
MAKO Series LED Area Light
2
STEP 2:
When the pole is inside the spigot, fasten the screws, nuts and spring washers.
Locking bolts
4
Cable gland
Bubble level
STEP 4:
1. Get mains power supply cord into led driver compartment via cable gland.
See Figure 6.
2. Lock the gland to mains power supply cord tightly.
www.tigerlight.com.au
INSTALLATION INSTRUCTION
L
W
H
Screw
Nut
Mains power supply cord
0°