Download Print this page

HydroHoist UltraLift Series Owner's Manual

For ultralift 4,400, 6,600,8,800, shallow water, front mount, e-series
Hide thumbs Also See for UltraLift Series:

Advertisement

Quick Links

Rev B 08062020

Advertisement

loading
Need help?

Need help?

Do you have a question about the UltraLift Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for HydroHoist UltraLift Series

  • Page 1 Rev B 08062020...
  • Page 2: Safety Notice

    Ground Fault Circuit Interrupter (GFCI) device which is to be used in series with the user’s primary AC power source. The GFCI is an integral part of the HydroHoist boat lift and is designed to offer a limited measure of protection to the user against hazardous electrical conditions or shocks should they occur WARNING! If the user disables the control unit’s Ground Fault Circuit Interrupter (GFCI) Device, they are in direct...
  • Page 3: Front Mount

    IMPORTANT: WHEN PLUGGING IN THE CONTROL THERE WILL BE A 5 SECOND DELAY BEFORE THE CONTROL IS READY FOR USE. THIS ALLOWS THE SYSTEM TIME TO BOOT UP. The UL Triton Control can be utilized on the following models of HydroHoist products: • ULTRALIFT 4,400, 6,600, &...
  • Page 4 Basic Operations Raise Mode turns blower on and activates valve system to lift the vessel Power LED is solid GREEN during this mode • Raise Mode will automatically shut off after 10 minutes if STOP is not • pressed Lower Mode activates valve system to lower the vessel Power LED is solid GREEN during this mode...
  • Page 5 Advanced Functionality of the Control Set Boarding Height Timer allows you to lower the vessel to a set height off the water to load or unload your vessel while the lift holds the vessel from floating away Important: This feature MUST be set or used from the fully raised position with ONLY the boat on the hoist.
  • Page 6 Manual Lowering of Vessel “Manual Override” The Triton UltraLift Series Control is equipped with a Manual Override for lowering the lift. This would be used if there is loss of power to your control and you need to lower your vessel.
  • Page 7 Guide Rope Mooring Rope Solutions...
  • Page 8 Do not secure any part of the boat, boat accessories, or boat cover to the lift. Warning: Hoist is installed as either a pull-in or back-in. For safe operation, the boat can- not be loaded opposite to how the hoist is installed. Contact HydroHoist, LLC for any additional accessories and products at www.boatlift.com.

This manual is also suitable for:

Triton ultralift