Advertisement
Advertisement
Table of Contents
Summary of Contents for TRAK RACER TR80-SLIDER
- Page 1 TR80-SLIDER Manual...
- Page 2 STEP 1 Add the seat slider as shown below. Start with placing the rails with the flat side upwards and the metal protrusions facing inwards. The leaver should be pulled upwards to unlock the rails. Now slightly fasten the front bolt of the rails just enough to keep it in position but allow the rails to swivel at the back slightly to align the back bolt without any tension.
- Page 3 STEP 2 The leaver needs to be bent outwards a bit further than the actual width of both rails. Now place one side with the holes in the protrusions with the other side just above the rails and apply a bit of force inwards to overcome the resilience, now align the leaver with the other end of the rail’s protrusions.
- Page 4 That’s it, you are done! We wish you a lot of fun with your freshly built equipment. Thank you for choosing Trak Racer...
Need help?
Do you have a question about the TR80-SLIDER and is the answer not in the manual?
Questions and answers