Table of Contents
Advertisement
Quick Links
MILLI
RUSH 432, 632, 832
Table 1.0
FEATURES
Low Voltage
Easy install
Any leg cable
Ecotimer
SPECIFICATIONS
Recommeded use
Materials
Finish
Technology
Element
Options
Power entry
Voltage
Wattage
Standards
Safety rating
CLEANING RECOMMENDATIONS
This bathroom product should not be cleaned with abrasive materials eg. steel wool/scourers. Do not use any corrosive or
abrasive cleaning agents containing acids or scouring agents. Do not use organic solvents (terps, meths, thinners) to clean
matte black and white coated towel rails. Bleaches can also discolour products and therefore should not be used.
Use a soft cloth moistened with warm soapy water or a silicone based household wax/polish such as SC Johnson 'Pledge'
for general polishing and cleaning of the appliance. Fine scratching can be removed using the correct metal polish.
Recommended brands are 'Autosol' and 'Brasso Paste', both available in tubes from supermarkets and car care outlets.
Damage caused by any improper treatment is not covered by the product warranty- refer to Warranty Conditions on the last
page.
Disclaimer: Products in this specification manual must by regulation be installed by licensed and registered
trade people. The manufacturer/distributor reserves the right to vary specifications or delete models from
their range without prior notification. Dimensions and set-outs listed are correct at time of publication
however the manufacturer/distributor takes no responsibility for printing errors.
Tech Page Version 3.3
Safe installation in ANY zone
ALL wall types, pre-wiring IS required
Cable can enter left or right
Ecotimer included (*with transformer kit-not incl)
Residential and Commercial
Stainless steel 304 grade
Mirror polish, Matte Black
Dry element (no leaks)
Replaceable
Heated or Non heated
ANY leg, left or right
12V AC safety isolating transformer
432 - 17W, 632 - 17W, 832 - 19W
AS/NZS:60335.2.43
IPX7 (immersion at 1 metre for 30mins )
Please note: Each individual rail is sold separately.
To see the complete Kado range go to
www.reece.com.au/bathrooms
page 1 of 4
Advertisement
Table of Contents
Related Manuals for Milli RUSH 432
Summary of Contents for Milli RUSH 432
- Page 1 1 of 4 MILLI RUSH 432, 632, 832 Table 1.0 FEATURES Please note: Each individual rail is sold separately. Low Voltage Safe installation in ANY zone Easy install ALL wall types, pre-wiring IS required Cable can enter left or right...
- Page 2 2 of 4 MILLI RUSH 432, 632, 832 Fixed wiring INSTALLATION INSTRUCTIONS Transformer 12V wiring SAFETY This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Page 3 3 of 4 MILLI RUSH 432, 632, 832 2. PRE WIRING - CONTINUED. • For masonry walls using an angle grinder and masonry cutting disc, Remove wirenut from cut a 25mm deep slot from the cable leg to the eventual location of the ONE side only transformer, see Fig 2.0...
- Page 4 4 of 4 MILLI RUSH 432, 632, 832 COMPONENT LIST TRANSFORMER KIT (*TO BE ORDERED SEPARATELY) 1 x Black polytube 40mm 1 x Ecotimer 4 x Black polytube 5mm, to hold wire in masonry slot 1 x Electronic transformer...
Need help?
Do you have a question about the RUSH 432 and is the answer not in the manual?
Questions and answers