Griots Garage Digital Torque Wrench Quick Start Manual

Thank you for purchasing this fine product from g
ly set fastener torque with a convenient LCD and audible beep alert. Before operating the torque wrench, please read
this manual completely, and keep it nearby for future reference.

MAIN FEATURES

• Digital torque value readout +/- 2% CW and CCW accuracy
• Beeper and LED indicator for the user preset target torque
• Units of Measure (ft-lb, in-lb, N-m, kg-m)
• Power supplied by 4- AAA batteries

FUNCTION KEYS

Power on/off
Backlight function/Under program status, press to move to next digit
Enter the setting mode/Increase the value to program pre-set torque
Zero reset
M/u Memory/Measure model select between "track" and "peak" modes

BATTERIES

Before using the D
igital
the end of the handle. Insert four AAA batteries matching the -/+ polarities of the battery to the battery compartment.
Reattach the battery cover.

PREPARATION

Press the power on button
button to select the desired unit of measure; ft-lb, in-lb, N-m, kg-m. Press the + button to set the desired torque value.
The display will read "SET". After two seconds the display will read 000.0 or the last programmed torque value.
NOTE: If you wish to reset the torque value you may choose to press the Zero reset button
to read 000.0. Otherwise you may scroll through the digit sequence to set the desired torque value.
To set the desired torque value you must start with the digit at the far left. Using the + button scroll through the
digits until the desired number is displayed. Use the
through the digits until the desired number is displayed. Continue this procedure until the desired target torque value
is displayed. Press the M/u button to memorize the target torque value and exit torque setting mode.

MEASURE MODEL; "TRACK" AND "PEAK" MODES

Track mode will display the reading in real time when torque is applied to the fastener. This allows the operator
to monitor the display as they are turning the wrench. Track mode works well for assembly work when the operator
is able to position the display within easy viewing.
Peak mode allows the wrench to read the maximum torque applied to the fastener. The display will lock and
hold this reading when the force is released for the operator to review after turning the wrench. Peak mode works
well for tightening lug nuts when the operator may not be able to position the display for easy viewing.
SETTINg "TRACK OR "PEAK" MODE
Track mode is the default setting. Press the M/u button to scroll between peak or track modes. The word peak will
appear in the top left hand corner of the display when selected. Nothing will be displayed if track mode is selected
as it is the default setting.
D t
igital orque
t W
you must install the batteries. To start remove the battery cover located at
orque rench
to power up the wrench. The display should show 0.0. Press and hold the M/u
W
rench
' g . The D
riot s arage igital
• Operating range: 32°-104° F (0°-40° C)
• Peak and track mode selectable
• Auditing Auto Sleep after 2 minutes idle
• Ratchet Head: 45 teeth, square drive
button to move to the next digit. Using the + button scroll
t W enables you to accurate-
orque rench
to allow the display
1 ⁄ 2
"