Advertisement
Quick Links
Part #40121 D.P.M. w/Jump Start
Perfect Performance Products, LLC
Painless Performance Products Division
2501 Ludelle Street
Fort Worth, TX 76105-1036
800-423-9696 phone – 817-244-4024 fax
Web Site:
www.painlessperformance.com
E-Mail:
tech@painlessperformance.com
Advertisement
Summary of Contents for Painless Performance Products 40121
- Page 1 Part #40121 D.P.M. w/Jump Start Perfect Performance Products, LLC Painless Performance Products Division 2501 Ludelle Street Fort Worth, TX 76105-1036 800-423-9696 phone – 817-244-4024 fax Web Site: www.painlessperformance.com E-Mail: tech@painlessperformance.com...
- Page 2 A color copy of these instructions can be found at http://www.painlessperformance.com/InfoSearch/manuals.php Painless Performance Products recommends you, the installer, read this installation manual from front to back before installing this harness. Due to the variables in modifications that can be done to vehicles, reading this manual will give you considerable insight on the proper routing and installation of this harness.
- Page 3 This means the Main battery voltage must reach 12.6 volts before the Auxiliary battery will be allowed to charge. The DPM w/Jump Start P/N 40121 kit only contains the wires and terminals needed to install this kit between two 12 volt batteries. The DPM is designed to pass 280 amps of current continuously or 500 amps momentarily during a “Jump Start”.
- Page 5 Installation Steps: BE SURE TO REFER TO THE INSTALLATION SCHEMATIC IN ADDTION TO READING THE FOLLOWING STEP-BY-STEP INSTRUCTIONS. DISCONNECT MAIN BATTERY BEFORE INSTALLING! 1. Start by mounting the Digital Power Manager and Jump Start solenoid a safe distance away from any moving parts or hot spots under the hood; meaning keep the unit at least 3 feet away from headers or exhaust manifolds and away from any engine belts or hood hinges.
- Page 6 9. Next install the 6ga black wire from the 3/8” ground post on the DPM to a good ground on the vehicle. This step is just as important as the red wires connected in the previous steps. Examples of a good ground would be the engine block, chassis frame (with paint scraped off) or to the negative ( - ) post on the Main Battery.
- Page 7 How to manually jump start your vehicle: Once you determine the vehicles Main Battery (MB) is close to being dead and won’t start the vehicle it will be necessary to press the red jump start switch and then turn the key to the start position to allow the starter to utilize the available current from the Reserve Battery.
- Page 8 The Digital Power Manager has 5 (Five) states of operation: – this is when the Main battery’s voltage is at 12.6 and is not drawing a large amount of Slow Flash charge current, so the DPM is allowing the alternator to charge the Auxiliary battery as well. –...
- Page 9 Painless Performance Limited Warranty and Return Policy Chassis harnesses and fuel injection harnesses are covered under a lifetime warranty. All other products manufactured and/or sold by Painless Performance are warranted to the original purchaser to be free from defects in material and workmanship under normal use. Painless Performance will repair or replace defective products without charge during the first 12 months from the purchase date.