Page 3
SECURITY AND CONTENT Dear customer, Please read this instruction manual carefully. Incorrect assembly and disassembly may cause damage to the product or personal injury. This instruction manual contains the following items: - Removal of the dispense head from the beverage container - Disassembly of the dispense head - Cleaning of the dispense head - Assembly of the dispense head...
- Turn on the product ball valve “B”. Check for product leaks and rectify if leaking. DSI Getränkearmaturen GmbH Oberster Kamp 20 59069 Hamm Phone: +49 (0) 23 85 772 100 Fax: +49 (0) 23 85 772 249 Mail: info@dsi-group.net WEB: www.dispensegroup.com...
Page 5
- If the dispense head is fitted with a decompression valve, ensure it is functional and not leaking. - Check all seals for damage or brittleness regularly. - We recommend the use of gas detectors or gas bottles sufficiently small so that gas concentrations cannot reach a dangerous level in the workspace if a leak occurs.
Page 6
G-type, turn the dispense head anti clockwise to release it from the spear. DSI Getränkearmaturen GmbH Oberster Kamp 20 59069 Hamm Phone: +49 (0) 23 85 772 100 Fax: +49 (0) 23 85 772 249 Mail: info@dsi-group.net WEB: www.dispensegroup.com...
Page 7
4. Remove the beer line and the gas line. Loosen the nuts holding the beer and gas fittings in place. Note: Without stop cock or ball the liquid can leak from the beer line. 5. Remove the fittings from the body and the piston (Co²-adapter, lip valve, ball valve etc.).
Page 8
(reaction time prescribed by the agent). DSI Getränkearmaturen GmbH Oberster Kamp 20 59069 Hamm Phone: +49 (0) 23 85 772 100 Fax: +49 (0) 23 85 772 249 Mail: info@dsi-group.net WEB: www.dispensegroup.com...
Page 9
10. Brush the bodies S-type and Draft as well as the corresponding pistons with the cleaning brush (arti- cle-no. 550396). Brush the bodies A-type, G-type and combi as well as the corresponding pistons with the cleaning brush (article-no. 550395). Rinse all compo- nents with clean water.
Page 11
16. Pull the latch towards the grip and while holding it, push the whole grip downwards. Release the latch at the lowest positon so that it locks on to the dispense head. 17. If a ball valve is fitted, ensure that it is open.