Summary of Contents for LaserLight LL-2500
- Page 1 LL-2500 FOUR TUNNELS RED AND GREEN LASER SHOW SYSTEM User's Manual Read this manual before using. Do not attempt to open the housing or repair this device by yourself without contact us!
-
Page 2: Dmx Address Quick Reference Chart
DMX Address Chart This chart lists the DMX dipswitch setting for DMX address 1 through 511. Follow the instructions below to configure fixture dipswitches with you desired DMX address. DMX Address Quick Reference Chart DipSwitch Position DipSwitch Position DMX Address Page 9... -
Page 3: Troubleshooting
General instructions Notes: 1. DMX console can not be used in Master-Slave operation (Sound Active or AUTO mode ). Unpacking: 2. There should be only one master unit in Master-Slave operation. Thank you for purchasing this product. Please read user guide for safety and operations Troubleshooting information before using the product. -
Page 4: Technical Specification
Technical Specification Master-Slave Operation This mode will allow you to link up to 32 units together without controller. 1. Voltage: AC110V or AC220V-240V/ 50HZ-60HZ/ Fuse: 2A/250V 1. Install the units in a suitable position (laying or appending). 2. Rated Power: 30W 2. -
Page 5: Stand-Alone Operation (Sound Active, Auto Mode)
Front/Rear Panel DMX address calculation For DMX mode, DMX512 address from #1 to 9# dipswitches must be set, the address is set from 1 to 511. Each dipswitch represents a binary value. Dipswitch Value Dipswitch Value ＃1 ＃6 ＃2 ＃7 ＃3 ＃8 ＃4... -
Page 6: Dmx Control
DMX Control DMX value Static patterns Dynamic patterns DMX value Static patterns Dynamic patterns The system only accepts the DMX512 signal of international standard to control the system 65～69 V dot line 1 hori-line jump 195～199 ladder line 4 square turn mode, the laser pattern ON /OFF, the size, the position, the speed, etc.
Need help?
Do you have a question about the LL-2500 and is the answer not in the manual?
Questions and answers