DIGITAL DELAY Elite RPM Manual

Advertisement

Quick Links

Elite RPM Switch

WARRANTY AND DISCLAIMER

DIGITAL DELAY ELECTRONICS INC. WARRANTS THE PRODUCTS
IT MANUFACTURES AGAINST DEFECTS IN MATERIALS AND
WORKMANSHIP FOR A PERIOD LIMITED TO 1 YEAR FROM THE DATE OF
SHIPMENT, PROVIDED THE PRODUCTS HAVE BEEN STORED, HANDLED,
INSTALLED, AND USED UNDER PROPER CONDITIONS.
The company's liability under this limited warranty shall extend only to
the repair or replacement of a defective product, at the company's option. DIGITAL
DELAY ELECTRONICS INC. disclaims all liability for any affirmation, promise,
or representation with respect to the products.
The customer agrees to hold DIGITAL DELAY INCORPORATED AND
DIGITAL DELAY ELECTRONICS INCORPORATED harmless from, defend, and
indemnify DIGITAL DELAY INC. AND DIGITAL DELAY ELECTRONICS INC.
against damages, claims, and expenses arising out of subsequent sales of or use of
DIGITAL DELAY ELECTRONICS INC. products, or products containing
components manufactured by DIGITAL DELAY ELECTRONICS INC. and based
upon personal injuries, deaths, property damage, lost profits, and other matters
which BUYER, its employees, or sub-contractors are or may be to any extent liable,
including without limitation, penalties imposed by the Consumer Product Safety Act
(P.L. 92-573) and liability imposed upon any person pursuant to the Magnuson-
Moss Warranty Act (P.L. 93-637), as now in effect or as amended hereafter.
No warranties expressed or implied, are created with respect to the company's
products except those expressly contained herein. The customer acknowledges the
disclaimers and limitations contained and relies on no other warranties or
affirmations.
2036 Fillmore Street
Davenport, Ia. 52804
563-324-1046
www.racedigitaldelay.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Elite RPM and is the answer not in the manual?

Questions and answers

Summary of Contents for DIGITAL DELAY Elite RPM

  • Page 1 DELAY ELECTRONICS INC. disclaims all liability for any affirmation, promise, or representation with respect to the products. The customer agrees to hold DIGITAL DELAY INCORPORATED AND DIGITAL DELAY ELECTRONICS INCORPORATED harmless from, defend, and indemnify DIGITAL DELAY INC. AND DIGITAL DELAY ELECTRONICS INC.
  • Page 2 2036 Fillmore Street, Davenport, Ia. 52804 563-324-1046 www.racedigitaldelay.com Elite RPM Switch Instructions Congratulations on purchasing the latest shift controller from Digital Delay. The Elite RPM Switch has some new features so please read the instructions before using. Contents: Warranty and Disclaimer......…..........…………….….Page 1 The Terminal Strip...............………….....………...
  • Page 3 The Setup screens allow the Elite RPM Switch to be configured to best meet your needs. There are three Setup settings that need to be set before the Elite RPM Switch can be used. Once set, these values should not need to be adjusted unless a change is made to the vehicle setup.
  • Page 4 Shift Points The Shift Points are used to select at what RPM each shift will occur. The Elite RPM Switch can have up to four separate Shift Points RPM values entered. The Shift Point values can only be changed when the engine RPM is below 2,000 RPM or off.
  • Page 5 2036 Fillmore Street, Davenport, Ia. 52804 563-324-1046 www.racedigitaldelay.com Shift Output Test To test the shift output, with the engine off, hold down either of the change number buttons. Keep in mind the Ign. input needs to be enabled. After about two seconds the Shift output will activate and stay activated until the change number button is released.

Table of Contents