Dextra Verteco 3 Installation

Advertisement

Verteco 3 Installation
230-240V / 50-60Hz
IP20
IK00
DIL-0149-0001
1.

Trunking Mount Options

Slide the mount brackets out as shown below.
3.
5.
Lightrak KNX
Trunking
Secure the trunking
mount brackets to
the slide out
brackets using the
screw, nut and
plates provided.
(Bracket supplied by
others)
DIL-0149-0001
WARNING - THIS LUMINAIRE MUST BE EARTHED
This luminaire has been tested and is manufactured to comply with BS EN
60598 : specification for general requirements and tests. It should be installed by
a suitably qualified person in accordance with IEE.
CAUTION: there is a potential risk of electric shock from the LED boards when
the product is operational with the cover removed.
NOTE: INSTALLATION AND OPERATION OF THE LUMINAIRE BEYOND ITS
SCOPE OF SUPPLY WILL INVALIDATE THE WARRANTY.
2.
4.

Direct Trunking Mount

Various trunking mount
options are available.
The mount brackets in
the luminaire are
compatible with Canalis,
Zucchini and standard
50x50 trunkings. Please
enquire if you are unsure
whether the Verteco 3
can be mounted to your
trunking.
(Brackets supplied by
others)
6.
Revision - F
Attach the luminaire
to the trunking using
the mount brackets.
Close the latch on
the mount bracket.
5050 Trunking
Use the brass bush
and black plastic
spacers supplied with
the luminaire to
secure to mount
brackets similar to that
shown here. (Brackets
supplied by others).
18/07/2019

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Verteco 3 and is the answer not in the manual?

Questions and answers

Summary of Contents for Dextra Verteco 3

  • Page 1 The mount brackets in the luminaire are compatible with Canalis, Zucchini and standard 50x50 trunkings. Please enquire if you are unsure whether the Verteco 3 can be mounted to your trunking. (Brackets supplied by others) Attach the luminaire to the trunking using Lightrak KNX the mount brackets.
  • Page 2 Verteco 3 Installation Always ensure safety tethers (supplied) are threaded through the suspension holes in the rear of the fitting before moving on to subsequent fittings. Insert locking screw into the bracket as shown to ensure the luminaire is securely attached to the trunking.

Table of Contents