Instructions For Use - Hyundai HC 800 Instruction Manual

III. INSTRUCTIONS FOR USE
Before you can use the appliance, its batteries must be charged. The operation time for one
charge depends on the attachment used and workload. Attachment is around 40-60 minutes.
When using the cord, a continuous operation should not exceed 30 minutes.
To Charge/Recharge
1) B e certain Clipper is OFF.
2) C onnect the trimmer to the cable and then plug to the mains.
3) I t will take approximately 8-10 hours to fully charge the Clipper. Do not exceed the set time
of charging!
4) A fter charging, unplug the cable from the mains first and only then unplug the connector
from the appliance.
Optimize the working life of the battery
– Do not charge for more than 10 hours.
– Do not keep cord permanently plugged in.
– Discharge / run down the battery completely twice a year by letting the motor run until
it stops. Let the battery charge fully afterwards.
Assembly
First select the attachment you want to use for cutting purposes. You have 4 different cutting
attachments with different uses to choose from. All these cutting attachments (B1, B2, B3,
B4) are put on the appliance in the same manner. Follow instructions on pic. 2.
Cutting attachments B1 and B2 can be used with comb attachments with various length of
cutting. All these comb attachments C are put on in the same manner (follow the instructions
on pic. 3 and 4). When removing the comb attachment, proceed reversely (pic. 3 and 4).
Use
Hair clipping
– T he trimmer can be operated from the outlet with the adaptor connected or only from
the charged battery.
– The trimmer turns on and off with a switch A1 and A3. Turn the trimmer on only after all the
attachments have been properly placed and you are ready for trimming. Turn the trimmer
off immediately after use.
Clipping with hair comb attachment
You may use 2 kinds of comb attachments C for trimming, depending on the attachment
(B1, B2) used.
1) C hoose one of the two cutting attachments (B1, B2), on which you may then put on the
comb attachments C arbitrarily, depending on the desired haircut length (B1=C1; B2=C2).
Put this attachment on properly.
2) P ut on the desired comb attachment C depending on the chosen size of the attachment.
Then you can turn on the appliance.
3) M ake sure that the flat part of the comb is always in full contact with the scalp to obtain
an even result.
26 / 35