Kenwood KDC-C711 Instruction Manual page 2

Warning
The marking of products using lasers
(Except for some areas)
CLASS 1
LASER PRODUCT
The label is attached to the chassis/case and
says that the component uses laser beams that
have been classified as Class 1. It means that
the unit is using laser beams that are of a
w eaker class. There is no danger of hazardous
radiation outside the unit.
M arquage des produits utilisant un
laser (Sauf pour certaines régions)
CLASS 1
LASER PRODUCT
L'étiquette est attachée au chassis/boîtier de
l'appareil et indique que l'appareil utiliser des
rayons laser de classe 1. Cela signifie que
l'appareil utilise des rayons laser d'une classe
faible. Il n'y a pas de danger de radiation
accidentelle hors de l'appareil.
La marca del producto láser
CLASS 1
LASER PRODUCT
Esta etiqueta está colocada al chasis/a la caja e
indica que el componente funciona con rayos
láser de classe1.
Esto significa que el aparato utiliza rayos láser
considerados como de clase débie. No existe
el peligro de que este aparato emita al exterior
una radiación peligrosa.
A marca dos produtos usando laser
(exceto para algumas áreas)
CLASS 1
LASER PRODUCT
A etiqueta é presa no chassis/estojo e indica
que o componente utiliza raios laser,
classificados como sendo de Classe 1. Isto
significa que o aparelho está usando raios laser
que são de uma classe mais fraca. Não há
perigo de radiação maléfica fora do aparelho.
2
Downloaded from: http://www.usersmanualguide.com/
CA U TION
2
Use of controls or adjustments or performance
of procedures other than those specified herein
may result in hazardous radiation exposure.
In compliance w ith Federal Regulations,
follow ing are reproductions of labels on, or
inside the product relating to laser product
safety.
KENWOOD CORPORATION
2967-3, ISHIKAWA-CHO,
HACHIOJI-SHI
TOKYO, JAPAN
KENWOOD CORP. CERTIFIES THIS EQUIPM ENT
CONFORM S TO DHHS REGULATIONS N0.21 CFR
1040. 10, CHAPTER I, SUBCHAPTER J.
Location : Rear Panel
FCC WARNING
This equipment may generate or use radio
frequency energy. Changes or modifications to
this equipment may cause harmful interference
unless the modifications are expressly approved
in the instruction manual. The user could lose
the authority to operate this equipment if an
unauthorized change or modification is made.
N OTE
This equipment has been tested and found to
comply w ith the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment may
cause harmful interference to radio
communications, if it is not installed and used in
accordance w ith the instructions. How ever,
there is no guarantee that interference w ill not
occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, w hich can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the follow ing
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation betw een the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to w hich the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
N OTE
This Class B digital apparatus meets all
requirements of the Canadian interference-
Causing Equipment Regulations.
REM A RQU E
Cet appareil numérique de la classe B respecte
toutes les exigences du Reglement sur le
matériel brouilleur du Canada.