Advertisement
Available languages
Available languages
Quick Installation Guide
1U Ventilation panels
1.4)
Specification
Performance
Voltage
Frequency
Current
Operating temperature
Operating humidity
2) The importance of individual elements
2.1)
The meaning of information on the front LCD display
The 1U Lanberg ventilation panel has an LCD display on the front. Below is described meaning of the
information displayed.
Front LCD appearance
2.3)
The meaning of the buttons on the front LCD panel
1 button
Time settings
in 24-hour format
3) Assembly within ICT rack / 19" rack cabinets
Step 1) Select 1 unused 1U slot on the vertical mounting rails of the ICT rack / 19" / 10" rack and align those holes
with the holes found on the 1U ventilation panel,
Step 2) Insert up to 4 metal baskets, bent at the end, with mounting basis inside them, into up to 4 designated
holes (mentioned in point (1)), in such way, so the bent ends of metal baskets will slide, click into and grab
the designated holes on the vertical mounting rails, from the outside,
Step 3) Insert M6 screws from the outside into the cages with washers, and then tighten them. They should pass
through the selected holes (point (1)) of the vertical mounting rails.
4) Preparing and launching the front LCD panel
Step 1) Connect the 1U ventilation panel using included in the kit. The side with the IEC C13 plug of the cable
connect it to the IEC C14 socket of the device and the other side with the Uni-Schuko plug connect to the
power socket,
Step 2) Connect the thermostat detector included in the kit to the terminal connectors on the rear side of the
ventilation panel. Connect the plug with the red border to the terminal marked in red, and the blue one to
the black terminal,
Step 3) Using the red switch, which is located on the right side on front of the housing, turn on (button in I
position) or turn off (button in O position) 1U ventilation panel.
E-mail: support@lanberg.eu
www.lanberg.eu
Value
220 ~ 240 V
50 / 60 Hz
2 - 0.20 A ~ 0.28 A
4 - 0.40 A ~ 0.56 A
-20 ~ 80 °C
20 ~ 80 %
CLOCK
Time in the form
of 24 hours
2 button
Temperature settings
(10 ~ 50 °C)
Lanberg © 2015-2020
Performance
Speed @ 1 fan
Noise level @ 1 fan
Air flow rate @ 1 fan
Static pressure @ 1 fan
Impedance protection
TEM
The temperature
of the external
detector
(10 ~ 50 °C)
3 button
Button increasing the
value for function
settings in 1 ~2
buttons
Value
2500 ± 5 RPM
40 dB(A)
46 CFM
6.4 mm H
0
2
Yes - fans
FAN
Fan operation
status
4 button
Button decreasing the
value for function
settings in 1 ~2
buttons
PL
| EN
8
|
10
Advertisement
