TEM Opera Plus Series Operation Manual page 35

TEM
Pressing the UP Switch the 08 page will be shown where the transmitter FM Deviation frequency can be
displayed and if is it necessary adjusted. In this example the transmitter has ±75KHz deviation frequency.
0 8 M o d u l
M o d L e v e l
M o d A d j
[ |
Note: is possible that the available audio program sources such as Microwave Links, Satellite receivers, audio IP
coder, or other are not perfectly set to the same input audio level of FM Opera plus Transmitter. In this menu will
be possible to optimize many possible difference between Audio Program Sources and Transmitter Audio Input
Pressing the OK Switch will be possible to increase or decrease with 1KHz steps de FM Deviation Frequency
In this example the deviation is 69KHz, and no increasing FM deviation frequency steps are included
0 8 M o d u l
M o d L e v e l
M o d A d j
[ |
Now +6 steps increasing FM deviation frequency are included, and the output total FM deviation is ±75KHz
0 8 M o d u l
M o d L e v e l
M o d A d j
[ |
Pressing the UP Switch the 09 page will be shown where the Audio Changeover menu is present.
page use a scrolling lines sub-menu enabled by OK switch. Once select the line with UP or DOWN switches, press
OK switch and the cursor will be in the selection mode. To change the parameters use the ◄ or ►switch
A07EXXXX – 1 Unit Transmitters
a t i o n
= 7 5
= 0 0
□ _ _ _ _ _ _ _ _
a t i o n
= 6 9
= 0 0
_ □ _ _ _ _ _ _ _ _ _
a t i o n
= 7 5
= + 0 6
□ _ _ _ _ _ _ _ _
K H z
K H z
K H z
K H z
K H z
K H z
Page 35
NOTE: this