Advertisement
Quick Links
Advertisement
Summary of Contents for Jonsa SPAUN BLUBOX32
- Page 1 BLUBOX32 QUICK SET UP GUIDE...
- Page 2 BluBox Set Up Procedure Connect the IEC power cord to the BluBox Connect according to diagram below. Copyright © 2013 Jonsa Australia Pty Ltd. All Rights Reserved. •Specifications are Subject to Change without Notice•...
- Page 3 BluBox Set Up Procedure Power up Blubox Connect network cable from PC to Blubox BluCard 1 » » » On the PC, go to Start Control Panel Network and Internet Network and Sharing Centre Click on “Local Area Network” Click on “Properties”...
- Page 4 Write down or take a photo of user’s original settings here. You will need to revert to these settings once the Blubox finishes installation. Jonsa is not responsible for any loss of internet connections. Once the information in the properties is recorded, click on “Use the following IP address”...
- Page 5 BluBox Set Up Procedure Open your internet browser and in the address type: 192.168.1.250 Click the England Flag for “English” and click Expert Mode Click “Setup” Tick “Display all system files” Choose “Standard G” Tick “Display all system files” Choose “Standard G” Type “10700”...
- Page 6 BluBox Set Up Procedure Click “Load” Click “Choose File” and choose the backup file for BluCard 1 Click Upload and wait approx 30sec Click “OK” and wait for restart...
- Page 7 BluBox Set Up Procedure Take out network cable from BluCard 1 and connect to BluCard 2 Repeat Step (10) to (15), in (14) choose backup file for BluCard 2 Do the same for BluCard 3 with backup file for BluCard 3 Leave network cable connected to the BluBox and revert to your original settings in (9) Disconnect network cable.
- Page 8 7 Mallaig Way, 3 - 29 Birnie Avenue, NSW 1811 Canning Vale ® Lidcombe Australia WA 6155 AUSTRALIA NSW 2141 Australia saleswa@jonsa.com.au Australia +61 1300 660 155 +61 1300 250 407 www.jonsa.com.au sales@jonsa.com.au Copyright © Jonsa Australia Pty Ltd. All Rights Reserved.
Need help?
Do you have a question about the SPAUN BLUBOX32 and is the answer not in the manual?
Questions and answers